Efco Power SA 9500 Manual De Instrucciones página 14

WARNING! – Never remove the cowl when
the engine is running. The fan rotor could
en
cause serious bodily injury, especially to the
hands.
GB
Before you begin blowing, put on the required
safety equipment.
F
WARNING! - When working with the
blower, wear the required protecting
D
equipment:
1. Hearing protection.
E
2. Eye protection.
3. Face mask in dusty environments.
NL
WARNING! - Be careful, particularly if
left hand operation is applied. Avoid any
P
direct body contact with the exhaust outlet
area.
GR
WARNING! - Never start the blower if the
inspection cover is not closed, is damaged
TR
or cannot be closed.
WARNING! - Do not operate the blower
CZ
while standing on a ladder or a stand.
SK WARNING - Don't walk backward while
operating the machine.
RUS
WARNING - Never attempt to blow hot or
burning substances or combustible fluids.
UK
Start the blower as described on page 12. Work
according to the following instructions:
PL
1. Never blow air toward fixed objects such as
walls, large rocks, automobiles and fences.
2. When working inside corners, blow from the
H
corner and inward toward the center of the
work area. Otherwise, debris can fly up in
LV
your face and cause eye injury.
3. Never point the blower nozzle at delicate
plants.
EST
Work Area Precautions
LT
• Never allow children to operate your blower.
Only allow others to use this blower who
have read this Operator's Manual or received
RO
adequate instructions for the safe and proper
use of this blower.
• Do not work near electrical wires or buildings.
• Work only when visibility and light are
12
adequate for you to see clearly.
• Do not work from a ladder, this is extremely
dangerous.
Leave this operation for
professionals.
• Stop the engine before setting the blower
down.
• Be particularly cautious and alert while
wearing hearing protection because such
equipment may restrict your ability to hear
sounds indicating danger (calls, signals,
warnings, etc).
• Be extremely cautious when working on
slopes or uneven ground.
STARTING THE ENGINE
START-UP PROCEDURE
Blower controls – Control handle (Fig.13)
· To accelerate press throttle trigger (1)
together with safety lever (3).
· To start the engine switch (2) must be set to
"1".
· If you want to work with the engine at fixed
speed, press safety lever (3) and move lever
(4) towards the "+" mark until obtaining the
required engine rpm. To disable the fixed
speed setting, return the lever to the "-"
position.
· To stop the engine, set switch (2) to "0".
Starting
Before starting the engine:
· Place the machine on an area of flat ground.
Check that the switch (2, Fig.13) is not in
·
position "0" (off ).
· Make sure that there is no one near the
machine and/or in front of the blower tube.
Starting a cold engine (engine stopped for
more than 30 minutes)
· Press the primer bulb (A, Fig.12) fully down,
slowly, 10 times.
· Lower the choke lever (B, Fig.12) until you
hear a click.
· Check that the switch (2, Fig.13) is in position
"1" (on).
· Place your left hand on the engine cowling
and your left foot on the frame to keep the
machine steady.
· Use your right hand to pull the handle (4,
Fig.1) until you encounter slight resistance.
Without releasing the rope, pull with a short
sharp gesture. Pulling with insufficient force