Descargar Imprimir esta página

Songmics RDT18W Manual De Instrucciones página 5

Publicidad

Hinweise(DE) / Nota(FR) / Notes(EN) / Note(IT) / Notas(ES)
Guide of Manual
Please read the assembly and safety instructions thoroughly, and use the product in accordance with the
Ÿ
intended purpose. It is recommended to save the manual for future reference. When offer the product to the
third party, please transfer the manualsimultaneously.
The texts and diagrams are illustrated as detailed as possible. For clarity, not all the details of every possible
Ÿ
variation and installation methods canbe described. The texts and diagrams are given only as examples. If
you require further information or face some problem, please contact and consult the seller.
It is strictly prohibited to copy, sell, modify or translate this manual entirely or partially for any purpose without
Ÿ
the express written permission of Songmics International GmbH. Songmics International GmbH reserves all
rights.
Notes
The product is intended for indoor use only, not for commercial use or outdoor use.The seller does not
Ÿ
assume any responsibility or liability with respect to any damage caused by incorrect assembly or improper
use.
To prevent tipping over, the furniture must be fixed to the wall with the safety fitting provided. Different wall
Ÿ
materials require different types of fixing devices.
If needed, please purchase the suitable fixing devices at local retail store.
Ÿ
Pleasecheck if the table is intact and if the components are complete before assembly. Do not place the
Ÿ
edge of the unwrapped componentson the floor to avoid the fray or damage.
It is recommended that two adultsfinish the assembly. To avoid damaging the product, please assemble the
Ÿ
unit on the flat, clean and soft floor.
Follow the assembly steps shown in the diagram to position and adjust the parts,then gradually tighten all
Ÿ
screws.
We do not suggest to use electric drill for inserting the screws. It may damage to the product. Please use
Ÿ
hand screwdriver (not supplied).
After the assembly, please place the dresser table in a ventilated area. The odour will disappear after two
Ÿ
days.
Periodically check the firmness of all the screws and connected position.
Ÿ
Nevertouch with sharp objects or corrosive chemicals, which may spoil the surface of the table.
Ÿ
Make sure all surfaces are protected from heat and liquids by mats and coasters. Wipe up the spills
Ÿ
immediately and ensure that a mat or pad is placed under paper if you are writing.
Protect the article from sunlight exposure or rain, and do not put itin a humid place. It mayaccelerate the
Ÿ
distortion, discoloration or fuissure.
Do not store heavy objects in the drawers. It may cause the article deformed or the paint flake off. After the
Ÿ
assembly, please do not shake or strike the table to avoid the components deformed or falling apart.
Please seek assistance and take care when moving the furniture. Prohibit rudely dragging the table as
Ÿ
careless handling may case the damage or injury.
It is recommended that before moving to a new location the dresser table is completely disassembled to
Ÿ
avoid personal injury or damage to the furniture. Please be careful to retain all fittings after the disassembly.
For daily care, please use a soft cloth with neutral detergent if necessary, then dry the surface.
Ÿ
5

Publicidad

loading