Domo DO7345H Manual De Instrucciones página 27

Calentador cerámico
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
USE
Before you use the appliance: plug in the appliance and turn on the on/off switch at the back of the device.
The heater is now in stand-by mode. You can set the appliance using the control panel, but also using
the remote control. You can make the settings in the same way. The display will show you the selected
settings.
ON/OFF SWITCH
Push the on/off switch to turn on or off the appliance. A signal will indicate that the appliance is operating.
After switching off, the appliance will cool itself for a while. The heater remembers the last settings made.
So when you switch on the device again, the last made settings will appear on the display.
POWER SETTING
·
Push once the button: high power: 2000 W
·
Push twice the button: low power: 1300 W
ECO
ECO MODE
Press this button to switch on the eco mode. With this function, the temperature will be set on 22°C as
standard. This way, the temperature will be maintained in an as energy-efficient way as possible.
·
If the ambient temperature is lower than 18°C, the appliance will make sure the set temperature is
reached at the higher power.
·
If the ambient temperature is between, 18°C and 22°C, the appliance will make sure the set
temperature is reached at the lower power.
If the temperature is reached, the appliance will enter the stand-by mode. If the temperature is
decreasing again, the appliance will re-enter the eco-mode. You can also set the timer in this mode.
OSCILLATION
Press the oscillation button to allow the heater to oscillate from left to right and vice versa.
TURN ON/OFF THE FIREPLACE EFFECT
Press this button to turn on/off the fireplace effect. You can use this appliance with or without the fireplace
effect, but you can also turn off the appliance and only turn on the fireplace effect.
TIMER
1.
Push this button to set the timer.
2.
The timer can be set between 1 and 24 hours. Use the + and - button to select the desired time. By
pressing the + or - button you set the time with one hour more or less. You can also press and hold
this button until you reach the desired setting.
3.
When the selected time has been expired, the appliance will enter the stand-by mode and will no
longer emit heat.
www.domo-elektro.be
27
DO7345H

Publicidad

Tabla de contenido
loading

Tabla de contenido