Operation; For Low Pressure Inflation; Less Than 20 Psi; Inflation Of Items That Require - CH RP4200 Manual De Instrucciones

Operating Instructions

Operation

FoR loW PRessuRe InFlAtIon -

InFlAtIon oF IteMs thAt RequIRe less thAn 20 PsI
1a . If inflating a low pressure tire, attach universal adapter to valve stem with the
locking lever in the open/up position . Be sure to press the universal adapter onto
the valve stem thread completely . Failure to do so could lead to loss of tire pressure
during this process .
b . If inflating a sports ball, insert a metal inflation needle into the universal adapter .
Make sure the needle is secure in the adapter .
2 . When the universal adapter is firmly in place, press the locking lever down . (See
Figures 3 and 4) .
3 . Plug a standard power cord into the inflator power inlet .
4 . Turn pressure selector dial to the "LO" setting (LO setting is just below 20 psi
setting) . (See Figure 5) .
5 . Press power button . (See Figure 6) .
6 . When item reaches desired firmness, press power button again to stop inflation .
The actual pressure will then read on digital gauge . (See Figure 7) .
7 . If more inflation is needed, repeat steps 5 and 6 .
Over inflation can be dangerous.
Pay attention while inflating low pressure items

FoR stAnDARD tIRe InFlAtIon -

InFlAtIon oF tIRes BetWeen 20 PsI AnD 99 PsI

1 . Attach universal adapter to valve stem with the locking lever in the open/up
position . Be sure to press the universal adapter onto the valve stem thread
completely . Failure to do so could lead to loss of tire pressure during this process .
2 . When the universal adapter is firmly in place, press the locking lever down . (See
Figure 4) .
3 . Plug a standard power cord into the inflator power inlet .
4 . Turn the pressure selector dial until desired pressure is reached . (See Figure 5) .
5 . Press power button . (See Figure 6) . Unit will turn off automatically when set
pressure is reached .

Maintenance

1 . This product has no user serviceable parts and does not require lubrication .
2 . Do not store outdoors . When not in use, store in a cool dry place .

InstRuCtIons FoR RePlACIng Fuse

1 . Shut off power to the unit .
2 . Use a flathead screwdriver to turn fuse cap counterclockwise .
3 . Replace old fuse with a 4A, 125V glass fuse .
4 . Reinsert fuse cap so that the word PUSH is on top and the image (
bottom .
5 . Use a flathead screwdriver to turn fuse cap clockwise .

teChnICAl seRVICe

For information regarding the operation or repair of this product, please call
1-800-543-6400 .
6
www.chpower.com
to prevent over inflation.
loCk
Figure  - lock universal Adapter securely
Figure 4 - Pressure selector Dial
Figure 5 - Power Button
Current
Pressure
Figure 6 - Digital Pressure gauge
) is on the
Figure 7 - Replace Fuse
loCk
Universal
Adapter
Valve
Metal
Stem
Needle
Desired
Pressure