Operating Instructions; Unpacking The Appliance; Electricial Information - CENTRI 772 Instrucciones De Uso

WARNING:
THIS APPLIANCE MUST BE EARTHED
The mains lead of this appliance is fitted with a BS 1363 A 13
amp fused plug. To change a fuse in this type of plug use an
A.S.T.A. approved fuse to BS1362 type.
B
1. Remove the fuse cover (A) and fuse (B)
2. Fit replacement 13 A fuse into fuse cover
3. Refit both into plug
IMPORTANT:
The fuse cover must be refitted when changing a fuse and if the
fuse cover is lost the plug must not be used until a correct repla-
cement is fitted.
Correct replacementes are identified by the colour insert or the
colour embossed in words on the base of the plug.
• Replacement fuse covers are available from your local Elec-
tricity Board Shop.

Operating Instructions

Congratulations on your new purchase
We recommed that you read these instructions carefully
in order to quickly become familiar with your new
appliance.
A good appliance, which is used properly, will serve
you for many years.

Unpacking the appliance

Dispose of packing materials in accordance with local
regulations.
Check the spin dryer for any transport damages, which
must be reported to the forwarding agent or goods
office responsible within 24 hours. In case of damage,
kindly send all relevant paperwork to the Customer
Service for further treatment.
Preparation for Use
1. Put the operating lever in the "OFF" (0)
position.
10
ELECTRICAL INFORMATION
A
A
HOW TO CONNECT AN ALTERNATIVE PLUG
If the fitted plug is not suitable for your socket outlet, then it
schould be cut off and disposed of in order to avoid a possible
shock hazard should it be inserted into a 13 A socket elsewhere.
A suitable alternative plug of a least 13 Amp rating e.g. 15 Amp
round pin to BS546 should then be fitted to the cable.
The wires in this mains lead are coloured in accordance with the
following code: –
BLUE – "NEUTRAL" ("N")
BROWN – "LIVE" ("L")
GREEN AND YELLOW – "EARTH" ("E")
1. The GREEN AND YELLOW wire must be connected to
the terminal in the plug which is marked with the letter
"E" or by the Earth symbol
green and yellow.
2. The BLUE wire must be connected to the terminal
which is marked with the letter "N" or coloured black.
3. The BROWN wire must be connected to the terminal
which is marked with the letter "L" or coloured red.
YELLOW & GREEN (E)
2. Open the lid.
3. Remove the transport safeguard from inside the
spin drum.
4. We recommend that the spin drum be washed
out with a standard detergent before using for
the first time.
5. Place the spin dryer on a level floor at a
distance of about 50 cm away from the
wall or other objects. Never balance out
irregularities in the floor surface by laying wood,
paper or similar materials under the appliance.
Loading the machine
1. Place a sufficiently large container for excess
water under the outlet spout.
2. Plug the appliance in to a mains socket (please
observe the Points of Safety).
or coloured green or
BROWN (L)
cable
clamp
BLUE (N)
B