Oregon 760 Manual De Instrucciones página 9

MAINTENANCE
• Every thirty days apply light machine oil to the
rear wheel support and the Tension Arm Interface.
(Figure 9) Two drops of oil is su cient.
1
3
FIGURE 9
WARNING:
DISCONNECT THE MACHINE FROM
ITS AC POWER SOURCE BEFORE
BEGINNING ANY MAINTENANCE.
• Every thirty days check the v-belt tension. If you
can hear the belt "slap" the V-belt Guard (Item 4,
page 5) when the drive motor starts, the v-belt
requires re-tensioning. Do this by loosening the
four bolts (Figure 10) that secure the motor to
the machine base and slide the motor toward
the rear of the machine. Tighten the four bolts.
2
4
5
FIGURE 10
9
• Vacuum daily or otherwise remove dust and debris
build-up from the machine and the machine belt track.
There are no other maintenance actions
required. All bearings are sealed for life and
require no additional lubrication.
REAR WHEEL SUPPORT AND
TENSION ARM INTERFACE
INSIDE HOUSING BELOW TENSIONING HANDLE
TENSIONING HANDLE
TENSIONING BUTTON
V BELT GUARD
FOUR MOTOR BOLTS
Operation