Silk’n Glide Xpress Instrucciones De Uso página 14

and progressing sequentially towards the other end helping you avoid treating the same area more than
once or overlapping skin areas. When pulsing, the Silk'n Glide™ TREATMENT SURFACE is designed
to create temporary pressure marks on the treated area. In every repositioning of the TREATMENT
SURFACE use these pressure marks to guide you for proper positioning of the next pulse, avoiding both
gaps and overlaps between pulses.
Try to avoid overlapping pulses!
Do not treat the same area of skin more than once per hair removal session!
Treating the same area of skin more than once per session increases the likelihood of
adverse effects.
GLIDING
GLIDING is the best way to work within the low energy levels and achieve a fast and more efficient session.
When Gliding, hold the PULSE TRIGGER down continuously, and using a slow, sliding motion while keeping
contact with the skin, smoothly move the device along the treated area. In the lower energy levels the
device takes only 1-1.5 seconds to recharge between pulses and provides a nonstop sequence of flashes.
If your skin blisters or burns, STOP USE IMMEDIATELY!
The Skin Color Sensor
Light-based hair removal on darker skin tones can result in adverse effects such as burns, blisters, and
skin color changes (hyper- or hypo-pigmentation).
To prevent such misuse, a unique SKIN COLOR SENSOR in Silk'n Glide™ measures the treated skin
complexion at the beginning of each session and occasionally during the session. If the SKIN COLOR
SENSOR detects a skin tone that is too dark for Silk'n Glide™ application, the device will automatically
stop emitting pulses.
If you see no light pulse and the READY/SKIN TONE WARNING INDICATOR LIGHT is rapidly
blinking, this is an indication that your skin tone, measured by the SKIN COLOR SENSOR, is too dark
for safe application. Try using the device on a different body part or contact Silk'n™ support.
12