Corradi Palladia Manual Del Usuario página 19

Palladia®
VERSIONS AND MOTORS
1 WIDTH
2 PROJECTION
3 HEIGHT OF WALL SUPPORTS
HEIGHT PILLARS
4
PALLADIA® PALLADIA® WALL-TO-
PITCH WALL PITCHED
3
3
4
2
PALLADIA
2 RUNNERS
1
PALLADIA®
5 RUNNERS
1
Rev. 1 - 5.2018
PALLADIA®
FLAT
4 3
2
2
PALLADIA®
3 RUNNERS
1
CORRADI SRL - USER MANUAL
PALLADIA® WALL-TO-WALL
FLAT
3
4
4
2
PALLADIA®
4 RUNNERS
1
Type 1
PLAN MOTOR
220 Volt motor-reducer - 218 W complete with limit switch with
button for raising and lowering. Ideal for flat awnings with 2 or more
runners because the canvas is never in tension; or for pitched awnings
with up to 3 runners with a maximum projection of 350 cm.
Type 2
SLOPE MOTOR
MONO CONTROL UNIT
220 Volt motor-reducer - 218 W with control unit equipped with
voltage control microprocessor and receiver for radio frequency
remote control (433.42 MHz), with two-channel emitter. Ideal
for pitched awnings with 2 or 3 runners to always ensure proper
canvas tension for each movement that can change based on
the expansion of the fabric or of the runners due to temperature
variations.
Type 3
SLOPE (CONTROL) MOTOR 1
PLUS MOTOR 2
TANDEM CONTROL UNIT
220 Volt motor-reducer - 218+218 W with control unit equipped
with voltage control microprocessor and for the operation of two
motors in series on the same axis, equipped with receiver for radio
frequency remote control (433.42 MHz), with two-channel emitter.
Ideal for pitched awnings with 4 or more runners to always ensure
proper canvas tension for each movement that can change based
on the expansion of the fabric or of the runners due to temperature
variations.
3 of 14