Troubleshooting - LUCCI UC7087T Manual De Instrucciones

Installation Instructions
Press the FAN TIMER button to activate the timer function, and then press the UP/DOWN buttons to set the time
at what you preferred. The fan and light will turn OFF at the set time. Fan timer can be cancelled anytime by
setting the timer to 0 (zero hours).
LIGHT TIMER Function
Press the LIGHT TIMER buttons to activate the timer function, and then press the UP/DOWN buttons to set the time
at what you preferred. The light will turn OFF at the set time. Light timer can be cancelled anytime by setting the timer
to 0 (zero hours).
NOTE: When using the FAN AUTO function and TIMER function, ensure the remote is in the same room or
within the transmission/receiving range.
The remote has memory function. If the fan or light is turned off by the double pole wall switch, it will memorise and
recover the last status when the double pole switch turned on next.
Trouble shooting
Warning:
For your safety, ensure the power is switched OFF before starting the troubleshooting procedures
TROUBLE
1．No functions operate
Warning:
Some tasks are
only to be performed by a
qualified technician.
2. Remote LED/LCD no
display.
3. Operates only at close
range.
4. More than one fan
operates interference at
same area.
9 | P a g e
PROBABLE CAUSES
Main power not restored.
Wall switch power to the fan
remote is OFF.
Receiver wiring incorrect.
Transmitter and receiver DIP
switches do not match.
The remote is too far from the
receiver.
Battery too weak.
Batteries at wrong polarity.
The contacts in battery
compartment are corroded or bent.
Poor contact with batteries.
Signal blocked from reaching
receiver.
Batteries too weak.
RF interference.
SUGGESTED REMEDY
Replace fuse. Turn ON circuit breaker. Turn
ON wall switch.
Switch wall switch ON, to power the
Verify wiring connections according to label
and wiring diagram.
Set transmitter and receiver to same DIP
switch setting.
Move closer to receiver.
Replace with all new batteries. Do not mix
the old and new batteries.
Reinstall the batteries at right
Clean corroded contacts.
Bend contacts back to their correct
position.
Roll the batteries to get them to sit in the
compartment, or replace with other brand
batteries.
Extend antenna out from canopy, or move it
for better reception.
Replace with all new batteries. Do not mix
the old and new batteries.
Change DIP switch settings to a different
code. Each pair of transmitter and receiver
must have unique DIP switch code
remote.
polarity.