Components; General Safety Warnings - Corradi Aura Manual Del Usuario

Aura

GENERAL SAFETY WARNINGS

Important safety instructions
Caution:
For personal safety it is important to follow these instructions.
Keep these instructions
General warnings
Each Corradi product has a specific function described in this manual; any other use and different from the one indicated, the use of non-original
components, any tampering and/or unauthorised technical modification, relieves Corradi from any responsibility for any injuries to persons and
animals and damage to property deriving from the activity.
Any modifications made personally or by third parties not authorised by Corradi (tampering, technical modifications, etc.) on Aura or its
components during the warranty period immediately renders the warranty void. In this case and in these conditions, Corradi will be relieved
from any liability and from any direct or indirect consequential obligation deriving from the unauthorised work.
Please always keep in mind that each moving part can represent a hazard.
Make sure that while opening/closing the panel there are no people in the vicinity of its operating range.
Do not allow children to play with the product.
It is forbidden to hang on to or support oneself on the framework: risk of serious injury to people and damage to the product.
Corradi reserves the right to modify its products at any time, at its sole discretion and without notice.
Installation
Product installation must be performed only by qualified technical personnel, who have received appropriate training and have been authorised
by Corradi.
Personnel must also meticulously observe safety regulations in force.
Safety during maintenance operations
All maintenance inspection, repair or adjustment operations of the product must be performed by qualified technical personnel.
Cleaning with ladders, scaffolding or other equipment should be done by specialised personnel only.
It is advised to put a warning sign on the power supply main switch with the following indication: "Do not touch. Service personnel at work". It is
advised to put a warning sign on the power supply main switch with the following indication: "Do not touch. Service personnel at work".
Rev.0_05.2018
Symbols
Symbols are employed to draw the user's attention to
specific subjects for the safety of people, of the product, or
to indicate special operating conditions.
Attention general hazard - possibility of damage to people,
property, components.
Attention electrical hazard.
Attention Shearing/crushing hazard.
CORRADI SRL - USER MANUAL
Safety in case of wind loads
Panels must be stacked when the wind speed
exceeds the speed equivalent to the wind resistance
class (indicated on the attached declaration of
performance) according to standard EN 13659.
To easily assess the wind speed in relation to the resistance classes,
please refer to Table "Wind resistance classes according to EN
13659" (chapter "Tables").
For non-standard products and/or other special cases the only
valid value in terms of wind resistance is the one indicated in the
offer sent by Corradi to the Authorised Retailer.
Important: keep the panels always retracted (stacked) if they are
not supervised.
5 of 12