Dmx-Protocol 16 Bit-Resolution (8 Bit-Resolution) - Futurelight DJ-HEAD 575 WASH Manual Del Usuario

Controlling:
After having addressed all DJ-HEAD 575 WASH, you may now start operating these via your lighting
controller.
Note:
The modes of DMX 512 data and lamp are shown via the display:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the the display will show "A001" with the actually set address. If there is no data received at the
DMX-input, the display will flash.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol 16 Bit-resolution (8 Bit-resolution)

Control-channel 1 (1) - Horizontal movement (Pan) (within 530°)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 2 (2) - Vertical movement (Tilt) (within 280°)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 3 - Pan-movement with 16 Bit-resolution
Control-channel 4 - Tilt-movement with 16 Bit-resolution
Control-channel 5 (3) - Pan/Tilt-speed
Decimal Hexad. Percentage S/F
0 0 00 00 0% 0%
1 249 01 F9 0% 98%
250 252 FA FC 98% 99%
253 255 FD FF 99% 100%
Control-channel 6 (4) - Switch on/off the lamp, reset, speed control of cooling fan
Decimal Hexad. Percentage S/F
0 127 00 7F 0% 50%
128 139 80 8B 50% 55%
140 229 8C E5 55% 90%
230 239 E6 EF 90% 94%
240 255 F0 FF 94% 100%
S Maximum speed (tracking mode)
F Decreasing speed (vector mode)
S Maximum speed (tracking mode), black-out while color changes
S Maximum speed (vector mode), black-out while Pan, Tilt moving or
color changes
F Decreasing speed of fan
S Switch on the lamp, reset, open position
S No function
S Switch off the lamp after 3 seconds
S No function
37/91
Feature
Feature
51839565_V_1_0.DOC