KEUCO Edition 400 Serie Instrucciones De Montaje página 5

Technical specifications
– Supply voltage:
– Max. power consumption:
– Protection category:
Prod No .: width
11X97 171000: 535 mm
11X97 171500: 710 mm
11X97 172000: 1060 mm
11X97 172500: 1410 mm
11X97 173000: 1760 mm
11X96 171000: 535 mm
11X96 171500: 710 mm
11X96 172000: 1060 mm
11X96 172500: 1410 mm
11X96 173000: 1760 mm
11X96 171001: 535 mm
11X96 171501: 710 mm
11X96 172001: 1060 mm
11X96 172501: 1410 mm
11X96 173001: 1760 mm
Operating instructions
Button Function
Switching the light on and off
• 1x briefly touch button.
– The light is switched on.
• 1x briefly touch button again.
– The light is switched off.
• 1x keep button pressed with light switched on.
– The light changes its brightness.
Release the button when the desired brightness is
achieved.
The brightness is saved automatically.
The device has two operating modes.
The operating mode can be changed with deactivated lighting by pressing
the On/Off switch for 15 seconds. Changeover of the operating mode is
signalled by a short flashing of the lamp.
Operating mode 1 (delivery condition):
The sensor switch is open after voltage return (e.g. after a power failure),
light is switched off.
Operating mode 2 (circuit with external light switch):
The sensor switch is closed after voltage return (e.g. after power failure),
lighting is on.
230 V AC / 50 Hz
15 W
IP20
light heating
10 W
13 W
19.5 W
26 W
32 W
10 W
13 W
19.5 W
26 W
32 W
10 W 26 W
13 W 41 W
19.5 W 65 W
26 W 90 W
32 W 2 x 41 W
5 - 20
Button Function
Switching light on and off
• 1x briefly touch button.
– The light is switched on.
• 1x briefly touch button again.
– The light is switched off.
Depending on the cabling, the light can likewise be switched
on and off from the light switch of the home electronic
system.
Dimmer
• 1x briefly touch button.
– The light changes its brightness.
The change stops automatically when the maximum value
is reached.
• 1x keep button pressed.
– The light changes its brightness.
Release the button when the desired brightness is
achieved.
The brightness is saved automatically.
Light colour: daylight white (DW)
• 1x briefly touch button.
– The light changes to daylight white (6500 K).
The change stops automatically when the maximum value
is reached.
• 1x keep button pressed.
– The light changes to daylight white (6500 K).
Release the button if the desired light colour is achieved.
The light colour is saved automatically.
Light colour: warm white (WW)
• 1x briefly touch button.
– The light changes to warm white (2700 K).
The change stops automatically when the maximum value
is reached.
• 1x keep button pressed.
– The light changes to warm white (2700 K).
Release the button when the desired light colour is
achieved.
The light colour is saved automatically.
Heating
• 1x briefly touch button.
– The heating is switched on.
– The light-emitting diode is illuminated in red.
• 1x briefly touch button again.
– The heating is switched off.
– The light-emitting diode goes off.
If no manual deactivation occurs, the heating stops
automatically after 20 minutes.