Password - Franklin Electric SubMonitor Manual De Instalación

Password

1. The password is factory preset to 0 0 0, which disables the password
protection. With the password protection disabled, all functions in the
menus can be changed by any user.
2. If the password protection is enabled, all parameters in the menus can be
viewed but not changed until the correct password is entered.
3. Using the password function:
a. Go into the Detailed Setup menu and select Change
Password. Enter the three digits of the password sequentially left
to right, just like a combination lock. Select >OK to return to the
Detailed Setup menu.
b. Go to the Basic Setup menu and select Enter Password. Enter
the password sequentially left to right.
4. If you forget your password, refer to the Enter Password screen which
shows a password code. You may call the FE Hotline at 1-800-348-2420
to convert the code into your three digit password.
5. The password resides in the Base Unit. If you change display units, you
will need to know the password that was used with the base unit.
6. If you wish to disable the password protection:
a. Go to Enter Password in the Basic Setup menu. Enter the
correct password.
b. Go to Change Password in the Detailed Setup menu. Enter
the password 0 0 0 sequentially left to right.
7. When a correct password has been entered, changes can be made for the
next 20 minutes. To get another 20 minutes, re-enter the password.
8. The 20 minute valid password interval is terminated if power is disconnected.
9. If the password protection is enabled, the Event History can be
reviewed after entering the correct password.
9