Battery Replacement And Charging; Troubleshooting - cecotec Conga 3290 Manual De Instrucciones

FREE-FALL SENSORS
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned off and in its
original package.

8. BATTERY REPLACEMENT AND CHARGING

• Do not use any other battery, power adapter or charging base than the one provided
offi cially by Cecotec.
• Do not use non-rechargeable batteries.
• Do not remove, dismantle or attempt to repair the battery or the charging base.
• Do not place the charging base near heat sources.
• Do not use a wet cloth to wipe any of the parts of this product.
• If the robot is not going to be used for a long time, remove the battery from the product
and store it in a dry and safe place. It is suggested to charge the battery every month in
order to avoid damage to the battery.
• Do not dispose of waste batteries at will. It is suggested to hand them over to professional
organizations for correct treatment.

9. TROUBLESHOOTING

Problem
The robot does not start up
or does not clean
The robot cannot charge or
return to the charging base
The robot does not work
properly
The robot emits a strange
noise during cleaning
Solution
• The robot cannot operate when the battery is low. Allow it
to charge before operating it.
• The room temperature is below 0 ºC or above 50 ºC.
Operate the robot in a room where the temperature is
between the stated temperature range.
• There are too many obstacles near the charging base,
relocate the charging base to an area free of obstacles.
• Clean the charging terminals.
• Make sure the power switch is turned on.
• The robot is too far away from the charging base, place it
closer and try again.
• There is very little free space around the charging base.
• Make sure the charging terminals are clean.
• Turn the robot off, switch it off and turn it on again.
• The main brush, side brush or omnidirectional wheel may
have foreign matters tangled, stop the robot and clear it up.
ENGLISH
35