Mounting The Milling Tools; Adjust Milling Fence; Change Spindle Mount; Application Notes - HOLZMANN MASCHINEN FS 160L Manual De Instrucciones

13.2.3 Mounting the milling tools

Only use cutters which. For the operation with a milling
machine table with max Spindle speed 8500 r
suitable, have a bore of 30mm, and with the standard
EN847-1: 2005 compliant.
Install the milling tool as low as possible.
Check that the spacer rings (E) are clean and in good
condition.
Choose to match the height of the milling tool spacer rings
(E). Complete with the spacer ring, the inside has a bolt so
that it is at least 2 mm over the spindle top. Insert the end
cap (D) on.
Now screw in the Allen bolt thread and tighten this firmly
on the rings.
Check immediately after mounting the free movement of the milling tool.

13.2.4 adjust milling fence

The milling stops are independently adjustable.
For profile milling adjust milling attacks exactly the same.
If you edit the entire workpiece side, you should set the End milling stop the milling reduction
accordingly, so that the workpiece is performed continuously.

13.2.5 change spindle mount

 The spindle lock.
 The Allen screw unscrew and remove the end cap.
 With the Allen key now, the change spindle be unscrewed from the spindle
receptacle.

Application notes:

Instructions for use of the spindle shaper:
 Prior to again the milling tool check for free running
 Check that the spindle lock is disengaged.
 Check that the spindle height is fixed by clamping.
 Pull the milling guard on workpiece width + max. 5mm attach.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
min -1 are
OPERATION
Allen screw
End cap
37
FS 160L