GREENLINE CM-400 Manual De Instrucciones página 8

Operation
Electric shock hazard:
Contact with live circuits can result in severe injury or death.
1. Set the selector and connect the leads according to the Settings Table. If using the manual
ranging mode, start with the highest measurement range.
Settings Table
To measure set the
this value ... selector to
this symbol ...
Ω
Continuity*
.
Current (AC)** V V
Ω
Diode
Ω
Resistance
Voltage (AC) V . V
Voltage (DC) V . V
* Tone indicates a circuit resistance of 20Ω or less.
** The jaw unit takes an AC current input and produces an AC voltage output. The ratio is
100:1. Every amp of input will produce 10 millivolts of output.
2. See Typical Measurements for illustrations of typical uses.
3. Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known functioning circuit, replace the
battery.
• If the unit still does not function as expected, send the unit to Greenlee for repair.
4. Take the reading from the circuit to be tested. If using the manual ranging mode and the
resolution is not satisfactory, remove the meter from the circuit and change to the next
lower range.
8
and press the connect the
function button red lead
until this icon to ...
appears ...
VΩ
AC N/A
VΩ
Ω
VΩ
AC VΩ
DC VΩ
and the
black lead
to ...
COM
N/A
COM
COM
COM
COM