User Guide; Starting Up Your Robot; Using The Damp Mop Kit; Technical Characteristics - Easymate Floor 200 Instrucciones De Uso

Warning: Do not use a hard bristle brush to clean the central brush. Make sure that the brush is dry before use.
e) Replacing worn side brushes (fig.6)
Make sure that the on/off button (4-Fig 2) is in the 0 position (off).
Remove the screw holding the side brush in place.
Remove the brush and replace it with a new side brush, being careful not to pull it by the 3 brushes.
Fasten the screws holding the side brush in place.
f ) Removing the rechargeable battery (fig.7)
Make sure that the on/off button (4-Fig 2) is in the 0 position (off) and that the robot has been disconnected from
the charger.
Remove the screw holding the battery cover in place and lift the cover.
Unclip the battery connector, being careful not to damage the electrical connections.
Replace the cover and tighten the fixing screws.
To replace the battery, follow this procedure in reverse.

5. USER GUIDE

a) Starting up your robot
Put the on/off button (4-Fig 2) into position 1.
Place the robot on the ground in the area you want to clean. It will start automatically.
Tip: Remove any potential obstructions from the area (low pieces of furniture, cables, wires, etc.).
b) Using the damp mop kit
Assemble the mop holder as explained in the INSTALLATION AND MAINTENANCE section.
Spray a cleaning product or clean water onto the mop head.
Remove any residual drops from around the mop holder.
Warning: Be careful not to completely soak the mop head as this may affect the movement of your robot. It is best
to use a spray to apply the cleaning product or water to the mop head.

6. TECHNICAL CHARACTERISTICS

a) Robotic vacuum cleaner (EASYMATE F200)
Reference: 330003
Power supply: 9V DC
Consumption: 300 mA
Volume of the dust collection bin: 0.45l
Dimensions: 60x290x290 mm
b) Power supply
230V-1A AC / 9V-300mA DC charger
Easymate by Extel - FLOOR 200 - 07/2017
GB4