Cleaning And Care; Error Codes - OK. ODW 121 Manual De Instrucciones

EN

CLEANING AND CARE

• Warning! When cleaning, never use solvents or abrasive materials, hard brushes, metallic or sharp
objects. Solvents are harmful to human health and can attack plastic parts, while abrasive cleaning
mechanisms and tools may scratch the surface(s).
• Clean the exterior surfaces of the product with a slightly damp cloth and dry them well. Make sure
that no water enters the product interior (e.g. at the switches).
• Clean the edge around the door using a soft, warm and damp cloth only. To avoid penetration of
water into the door lock and electrical components, do not use a spray cleaner of any kind.
Cleaning the filter assembly
The filter prevents larger remnants of food or other objects from getting inside the pump. Inspect the
filters for blocking every time the dishwasher has been used.
13 The filter system consists of a coarse filter, a flat (Main filter) and a micro filter (fine filter).
• Main filter A: Food and soil particles trapped by this filter are pulverized by a special jet on the
spray arm and washed down to drain.
• Fine filter B: This filter holds soil and food residue in the sump area and prevents it from being
deposited on the dishes during wash cycle.
• Coarse filter C: Larger items, such as pieces of bones or glass that could block the drain are
trapped in the coarse filter. To remove the items caught by the filter, gently squeeze the tap on
the top of this filter and lift out.
14 Disassemble and clean the filter according to following steps:
• Turn the filter cap (filter C) anticlockwise and take off whole filter assembly.
• Take out filters B and C.
• Take out filter C.
• Wash filters under running water.
• Reassembling is done in reverse order. Make sure the filter assembly is installed correctly.
Note: Do not use the dishwasher with filter system not installed.
Cleaning the spray arms
15 The spray arms can be easily removed for periodic cleaning of the nozzles, to prevent possible clogging.
• Grasp the middle of the spray arm, pull it upwards to remove it.
• Wash the arms under a jet of running water
• Return them carefully to their seat and make sure that the spray arms are installed correctly and
can turn freely.

ERROR CODES

Code
The "Sanft 40°" light flickers.
The "90 min. Programm" light flickers. Overflow
IM_ODW121_150402_V04_HR.indb 34
34
Meaning Possible causes
• Faucets is not opened
Longer inlet time • Water intake is restricted
• Water pressure is too low
• Some component of dishwasher leaks
2/4/15 4:24 PM