Advanced Elements AdvancedFrame Manual De Instrucciones página 5

2. Completely deflate all air chambers and reverse your pump to pump out all the remaining air. This will make folding easier.
3. Remove plastic bow and stearn forms, then lay kayak our flat
4. Fold in half, down the center (figure 5 step 1 and 2)
5.
For AdvancedFrame
6.
For AdvancedFrame2
the duffel bag to fold at correct length.
7. Place into duffel bag.
4. GUIDELINES FOR USAGE
Paddle sports can be very dangerous and physically demanding. The user of this product should understand that participation in paddle
sports may involve serious injury or death. Observe the following safety standards whenever using this product. The user of this product
acknowledges both an understanding and an assumption of the risk involved in paddle sports.
After you have inflated your kayak and before you put it in the water, inspect your equipment for obvious signs of wear and failure.
Review local rules and regulations and read again the safety warnings in section 1.
Many areas have local laws and regulations about the use and equipment of small boats. Usually a phone call to the local authorities
will provide you with the needed information. Some areas may require that you register and display a registration number on the front of
your kayak. Once you have been issued a number, it is best to affix it to the kayak by printing it on the material with a permanent ink
marker. If you are required to display a sticker or vinyl letters, an inflatable boat ID kit can be purchased at most marine stores.
Your kayak is designed to be paddled with a double bladed kayak paddle. Paddle with short and even strokes. Keep the blade close to
the kayak and the paddle almost vertical. Pull with your lower hand and push with your upper hand. To reduce the amount of swaying at
the front of the kayak, ease off the force of your stroke. Paddling with a backward stroke can sometimes offer quick maneuverability.
ALWAYS practice safety and take the time to learn about the area where you are paddling. Get official information about the local tides,
currents, and wind conditions before paddling there. Be careful that you do not over estimate your strength, your endurance, or your
skill. Be careful never to under estimate weather conditions. Be aware of the dangers before you begin. Be aware of your skill level. Be
sure you understand and accept the risk of these dangers. There are many paddling clubs all over the world. These can be a great
source of information on places to paddle, people to paddle with, and most importantly, continued safety practices.
5. PROPER CARE AND STORAGE
Your inflatable kayak is made of very durable materials. However, like anything else, proper use and care will increase the life of your
kayak. Before storing your kayak, make sure it is both CLEAN and DRY. You may clean your kayak with a mild soap and water. NEVER
use strong solvents to clean your kayak as they may destroy the material.
NEVER unzip the chamber cover when the kayak is inflated.
Be sure to rinse your kayak with fresh water after every use in salt water and allow it to dry thoroughly before storing. Use a dry towel to
wipe up all moisture. It should be deflated and kept out of direct sunlight when stored. Avoid exposure to extreme temperatures. If your
boat is exposed to freezing temperatures while storing, allow it to warm up before unfolding.
Do not store your kayak for an extended period of time while wet. Follow these steps for removing excess water:
1. Unzip the 2 zippers that run down the centre of the kayak.
2. Remove the grey fabric tube and cover, along with the inflatable floor, separating it from the outer cover. In order to
completely separate these parts, it is necessary to unscrew the locking nut on the spring valve.
3. Use a sponge or towel and wipe up any excess water in the outer cover.
4. Wipe off the floor (top and bottom).
5. If there is sand or gravel in the kayak, you can hose out the cover, and then wipe it own with a towel.
6. Most of the time you can just pull out the inflatable floor and wipe out the inside of the kayak absorbing most of the water, then
pack it up.
6. REPAIRS
All kayaks come with a repair kit that includes glue and several patches. This should remain with the kayak in the event that you may
need it. If service is required for your kayak, please contact your dealer.
6.1 Repairing Small Punctures and Cuts
1. Cut a rounded patch at least ½ to 1 cm larger than the hole or cut.
2. Clean the area where the patch will be placed with water and/or mild soap.
3. Make sure all surfaces are dry.
4. In a well ventilated area, spread a thin layer of glue on both the patch and the damaged area. Let it sit for three to five minutes
or until tacky.
5. Apply the patch over the centre of the hole or cut and apply pressure for 1 minute.
6. Do not inflate the kayak for at least twelve hours.
6.2 Repairing Pinholes
1. Inflate the PVC tube. Locate the pinhole by sponging soapy water over the tube until you see air bubbles. Mark the location of
the pinhole.
2. Deflate the tube and dry the affected area. Apply a drop of glue to the pinhole.
TM
, fold into 4 equal sections, see figure 5 step 3
TM
, AdvancedFrame Convertible
TM
, and AdvancedFrame Expedition
TM
, fold into 5 equal sections. Look at
5