Publicidad
Idiomas disponibles
Idiomas disponibles
EN
These instructions are for both the installer for installation and for
the user for operation and looking after the product. After installa-
tion, please hand them over to the user to keep.
Symbols and explanations
Attention! Warning against bodily injury or damage to
property.
Attention! Warning against electric shock.
Attention! Warning against water damage.
Note, tip or reference
Correct installation/test of functionality
Incorrect installation
Observe installation details
Optional/accessories
Switch on/off
Luminous colour daylight white
Luminous colour warm white
Light regulator (dimmer)
Heater
Safety information
– The electrical installation must be performed by a profes-
sional installer pursuant to IEC 60364-7-701/VDE 0100 part
701 must be observed! National and local regulations must
be observed!
– KEUCO strongly recommends that all its bathroom cabinets
containing a 230 V supply should be protected by an RCD
switch with a 30 mA protected circuit. Our shaver supply unit
complies with BS/EN 61558.
– Do not use the product if it or the power cable is damaged.
Have the manufacturer, customer service or a similarly quali-
fied person replace it instead.
– It must be ensured that the wall can bear the weight of the
mirror cabinet.
Intended use
Mirror cabinet with dimmable light and mirror heater for use in
damp locations, such as the bathroom or WC.
Product is only suitable for installation indoors!
Attention! Only install in frost-free places.
Declaration of conformity! This product satisfies the
requirements of applicable EU directives. The declaration of
conformity for this product can be obtained at the following
address:
KEUCO GmbH & Co. KG, Oesestraße 36,
D-58675 Hemer.
Technical specifications
– Supply voltage:
– Max. power consumption:
Prod. No.:
21543 1713XX:
– Protection category:
– Ambient conditions:
Temperature
– Luminous colour
4
Important information, please read!
230 V AC / 50 Hz
Width
Weight
Light
1410 mm
45 kg
52 W
2700 – 6500 Kelvin
Installation dimensions, refer to page 2
Included items, refer to picture 1 on page 12.
Connection diagram, refer to picture 2 on page 12.
Installation, refer to page 13 starting at picture 3.
Operation
Key
Function
Light on/off
• Tap the key to turn on the light, the white LED goes off.
• Tapping again causes the light to go off, the white LED
Dim the light
• With the light on press and hold the key.
• When the desired brightness is reached, stop pressing
• Tap the key, the light toggles between minimum and
The setting is saved and used the next time it is switched on
(only with operating mode 1).
Set luminous colour to daylight white
• Tap key.
Adjust luminous colour
• Press and hold daylight white key.
• When the desired luminous colour is reached, stop
The setting is saved and used the next time it is switched on
(only with operating mode 1).
Set luminous colour to warm white
• Tap key.
Adjust luminous colour
• Press and hold warm white key.
• When the desired luminous colour is reached, stop
The setting is saved and used the next time it is switched on
(only with operating mode 1).
Heater on/off
• Tap the key, the red LED illuminates.
• Tapping again causes the heater to go off, the red LED
After 20 minutes, the heater goes off automatically.
For spare parts with order numbers, refer to page 17.
Bulbs may only be replaced by the manufacturer, its customer
service or a similarly qualified person.
For warranty and care information please refer to the attached
warranty and care instructions.
Disposal information! Products with this mark may not be
disposed of in regular household waste, but must be brought to
a collection point intended for this purpose instead!
Heater
84 W
IP20
5° – 40° C
illuminates.
the key.
maximum level.
pressing the key.
pressing the key.
goes off.
Publicidad
