Koenic KRVC 2320 RC Manual De Instrucciones página 25

Cleaning and care
Warning
• When cleaning, never use solvents or
abrasive materials, hard brushes, metallic
or sharp objects. Solvents are harmful to
human health and can attack plastic parts,
while abrasive cleaning mechanisms and
tools may scratch the surface(s).
• Never immerse any electrical part of the
product in water or in other liquids during
cleaning. Never place it under running
water.
• Before cleaning, always switch off the
vacuum robot and disconnect the plug of
the charging base from the power supply.
Emptying dust container and cleaning
filters and mop cover
Note: The dust container should be emptied
every time after vacuuming.
Fig. After vacuuming, remove the dust
22
container. Press the release button and
pull it out.
Fig. Hold the dust container over a dust bin,
23
so that the opening with the yellow
flap faces upwards. This way, the dust
will fall downwards, when opening the
container.
Fig. After approx. 3 operating hours, but
24
at the latest when the performance
decreases, clean the dust pre-filter, fine
filter and HEPA filter. To do this, remove
all filter components and clean them
separately. The assembly is done in
reverse order. Make sure, that the filter
insert is correctly assembled. To ensure
this, press the shorter side wall into the
fitting first, before pushing in the filter
on the other sides by pressing down on
the edges.
IM_KRVC2320RC_190807_V10_HR.indb 25
Fig. Close the dust collector again and
25
insert it into the vacuum cleaner. Make
sure it is assembled properly.
Warning
Never use the device without a filter
Note:
• The two rotating brushes are subject to a
certain amount of wear, depending on the
type of hard floors you have (e.g. rough,
rustic tiles). Therefore, you must check
them at regular intervals to ensure, that
they're undamaged.
• Worn rotating brushes may have sharp
edges that can damage sensitive hard
floors, such as parquet or linoleum.
The Imtron GmbH does not accept any
responsibility for damage caused by worn
brushes
Fig. If the brush roller is blocked by or full
26
with hair, lint or similar residues remove
and clean it. Press the buttons on the
cap, remove the cap and then remove
the brush roller. Remove hair and
lint, etc. by hand or with a brush. The
assembly takes place in reverse order.
English
25
7/8/2019 14:43