Essentielb Mouv'up 32-75 Manual De Instrucciones página 8

assembly of the stand
!
It is the responsibility of the persons who assemble the stand to correctly install all the
components and hardware, as indicated in the assembly instructions.
1
I
F
14 6
V.2.0 V.2.0
assembly of the stand
G
G
2
To install the two fixed arms to the back of your screen, cover a stable and flat surface with a soft cloth.
•
Place the screen of your appliance on the soft cloth.
•
Locate the threaded mount points on the back of the screen.
•
!
Determine the correct screw length by carefully inserting a match or toothpick and
marking the depth of the mount point. Refer also to the operating instructions for your
screen.
If your screen has a curved back or a recessed mount point,
a spacer (T) must be used. Choose the spacer which is the
closest to the depth of the recess in order to hold the bracket
as close to the screen as possible.
Place the spacer between the fixed arm and the screen. Use
the washers supplied (E) with the screws (A) for optimal stability.
Do not forget to leave sufficient space at the back of your
screen to accommodate the connectors of your multimedia
devices (SCART cable, HDMI cable...).
The use of angled cables is sometimes necessary to avoid
3
damaging the connections to your screen.
Attach each arm to the screen, aligning the holes in each arm
with the threaded inserts on the back panel of your screen,
inserting the screws through the two holes and turning clockwise
using a crosshead screwdriver until they are completely tight.
To finish installing your TV on the stand, present the screen to
the backplate.
Place the top notch of the fixed arms on the back of the screen in
the top runner of the wall plate. Then tilt the screen downwards.
Remember to centre your TV carefully onto the mounting plate.
X
TV TV TV TV
V.2.0 V.2.0
assembly of the stand
15 7