Dust Extraction - Festool DSC-AG 230 Manual De Instrucciones

– They represent the primary applications of the
power tool.
Increase possible for other applications, with oth-
er insertion tools or if not maintained adequately.
Take note of idling and downtimes of machine!
7 Safety elements assembly
WARNING
Risk of accident, electric shock
 Always pull the plug out of the socket before
performing any type of work on the machine.
CAUTION
Immer Zusatzhandgriff [1-11] verwenden um
eine sichere und ermüdungsarme Arbeitshal-
tung zu gewährleisten.
7.1 Additional holder
Special construction "VIBRASTOP" regulates the
vibrations with additional holder [1-13]. Addition-
al holder can be screwed from the left or right
side of gearbox.
7.2 Rotating handle
By turning the main handle by 90° to the left or
right you achieve better handling of the tool.
Press the handle arrest button [2-5] and turn the
holder to the working position, where the arrest
button must again lock in.
7.3 Exhaust cover
Assembly
 Lay the grinder on the table edge with spindle
upwards and main hadle to left.
 Lock the exhaust cover in upper position and
mount into the grinder collar.
 The guide pad must be inserted into the groove
on the spindle collar fi gure [3].
 Turn the grinder clockwise into suitable work-
ing position – fi gure [4], set the cover to the
maximum cut-through and arrest in this posi-
tion.
 Tighten sleeve [5-2] with screw [5-1] – fi gure
[5]. During tightening observe uniform gap be-
tween sleeve and bearing cover indent, you will
achieve the right vertical position of bearing
cover in cover sleeve.
 The control of correct clamping should be car-
ried out according to fi gure [5 a].
22
Removal
 The cutting disc must be dismounted before
the disassembly of the exhaust cover.
 Set the cover to the maximum cut-through and
put it down with the grinder at the bottom.
 Loosen screw [5-1] of sleeve [5-2].
 Set the cover to the top position.
 Turn the guiding tab [5-3] into the groove on
the grinder's clamping neck.
 Remove the cover from the grinder's clamping
neck.
7.4

Dust extraction

WARNING
Dust hazard
 Always work with a dust extractor.
To ensure suction, put the hose of a Festool vacu-
um cleaner class M or H into the suction adapter
[1-11].
Warning: Always work with the suction connect-
ed. Use exclusively antistatic vacuum cleaners to
prevent discharges of static electricity in dusty
environments.
For enhancing of exhausting effi ciency, the cover
is equipped with changeable dust cover [6-1]. If
the dust cover loses its function by wear, change
it – see fi gure [6].
8 Diamond cutting disc
8.1 Clamping
WARNING
Do not use quick-change nuts for clamping the
disc!
WARNING
Only use diamond cutting discs recommended
by the manufacturer and the prescribed fl ang-
es included with the cover and the grinder.
- For reasons of safety, always use original Fes-
tool grinding discs!
- Sintered cutting discs must not be used!
- If the permissible revolution speed is given on
the disc, it must not be lower than the highest
no-load speed of the grinder.
- Discs with a permissible peripheral speed of 80
m/s and higher may be used.