Tannoy CVS Serie Manual De Instrucciones página 8

6.2. Installation Guide for Sheetrock Ceilings
6.2. Installation Guide for Sheetrock Ceilings
1. Mark the cut-out area on the ceiling by tracing around the
template provided. (Fig.1)
2. Cut out the hole in the ceiling using a pad saw, then slide the
C-Ring into the ceiling, aligning it over the cut-out hole. (Fig.2)
3. Go to section 7 for wiring and set-up instructions then return
to point 4 below.
4. Slide the speaker assembly through the hole and turn the
screws to extend the mounting wings. Tighten the screws until a
firm grip is achieved. If using a power driver, Tannoy recommends
a torque setting of 1.5 Nm. (Fig.3)
DO NOT OVERTIGHTEN!
5. Connect a secondary support line to safety tab. Some
construction codes require use of this secondary support point,
which should connect to a separate secure support point using a
suitable support line. Consult construction codes in your region.
6. Insert grille by pushing it onto the speaker. (Fig.4)
8
CVS (EN54) Operation Manual rev 1.1.1
Fig.1
Fig.2
Fig.3
Fig.4