How To Operate The Unit - JB Systems Light iRock 7S Manual De Instrucciones

ENGLISH
DMX-CONFIGURATION OF IROCK 7S-7B:
JB SYSTEMS®
OPERATION MANUAL
9/58 iROCK 7S-7B
ENGLISH

HOW TO OPERATE THE UNIT

Every time you turn the unit on, it will show Ir7b/Ir7s on the display and move all the motors to their 'home'
position and you may hear some noises for about 20 seconds. After that the unit will be ready to receive
DMX signal or run the built-in programs.
You can operate the unit in three ways:
o By master/slave built-in preprogram function
By CA-8 easy controller
o
By universal DMX controller
o
 BY MASTER/SLAVE BUILT-IN PREPROGRAM FUNCTION:
Select this function when you want an instant show. By linking the units in master/slave
connection, the first unit will control the other units to give an automatic, sound
activated, synchronized light show. Its DMX input will have nothing plugged into it, and
its master-LED will be constantly on and sound-LED will flash to the music.
Important! This function only works when the blackout mode in the menu of the
master is set to OFF, otherwise nothing will happen! Read more about this
option in the "Main Menu" paragraph.
 SLAVES have 2 working options: The other units are set to slave mode (slave-
LED is constantly on). In order to create a great light show you can introduce
contrast movements (pan/tilt of slave is inverted)  In the menu of the slave units
you can go to option and select:
 Normal slave: slave works in sync with the master.
o
 2 light show: slave works in opposite with the master.
o
 BY EASY CONTROLLER:
When used in Master/slave mode we strongly advice you to use the CA-8 "Easy controller" Just connect
this small controller to the 1/4" jack of the master unit, and you will be able to control the following
FUNCTIONS:
Stand by Blackout the unit
Strobe X/Y moving
1.Gobo/Color show mode
sync. strobe selection
Function
( Show 1 ~ Show
2.Sync. strobe
4 )
3.Two-light
strobe
Sound 1 Sound 2
Mode (LED off ) (LED normal
blinking)
JB SYSTEMS® 10/58
OPERATION MANUAL
Color/Gobo X/Y moving setting
selection 1.Pan position
1. Hold on for 2.Tilt position
gobo change. 3.Dimmer
2. Press shortly First set Master unit, then set Slave units'
for color position.
change.
Slow/Sound 3 Position/ Latch
(LED on) (LED fast blinking)
iROCK 7S-7B