Electric Shock Hazard; Preventive Maintenance - Dri-Eaz Sahara HD F352 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

READ AND SAVE THESE INSTRUCTIONS
WARNING

ELECTRIC SHOCK HAZARD

Keep motor and electrical parts
dry.
Do not operate in standing water.
Do not expose to rain, water or
snow.
Do not get the exterior, motor or wir-
ing wet.
Do not clean with wet objects, i.e.,
power washers, soap and water, etc.
If motor or electrical parts become
wet, allow them to dry completely
before using.
Read and understand manual be-
fore operating.
WARNING
FIRE HAZARD
Keep air intakes clear. Reduced
airflow can cause motor to over-
heat.
Clean any lint or other material
from the screens before each use.
Do not operate near draperies or
other material that could block the
air intakes.
Clean dust and dirt from motor
using a vacuum or compressed air.
Do not use or store where flamma-
ble vapors like gasoline, solvents, or
thinners are present.
Do not use near open flames, or
heat sources.
Read and understand manual
before operating.
07-01534J F352

Preventive Maintenance

Routine maintenance can significantly increase the life of your Tur-
boDryer. It also promotes efficient operation. The applications and
amount of use by owners vary, so the recommendations listed below
are for average-to high-volume use in water damage. Constant opera-
tion or use in other environments may require additional maintenance.
Contact Dri-Eaz for more information.
NOTE: Do not oil motor bearings; they are permanently oiled.
B
E
U
:
EFORE
ACH
SE
Inspect power cord for cuts, fraying or damage; do not use if dam-
aged.
Remove lint or obstructions from the grills using a vacuum or com-
pressed air.
Inspect exterior components (switch, knob, etc.) for damage.
Q
(
UARTERLY
OR AS NEEDED
Clean the exterior with a household all-purpose spray cleaner.
Spray the rag, then apply to the surface.
To renew shine on the plastic, use a vinyl cleaner.
Remove grill and blower, then blow off internal components with
compressed air.
A
:
NNUALLY
Inspect components and internal wiring for discoloration, loose con-
nections, or fraying.
O
U
F
T
THER
SES
OR
URBO
Cool and Ventilate
Place the airmover on a flat surface, and direct the air from cooler are-
as (including the outdoors) into a warm room.
S
F
T
D
TORAGE
OR
URBO
RYERS
Stackable
Units can be stacked (up to 3) on their sides for stor-
age. Stacking feature is not secure enough to be used
during transport.
2
WARNING
Always disconnect the TurboDryer from its power
source before performing any maintenance or
cleaning.
):
D
RYERS
Legend Brands, Inc.

Publicidad

Tabla de contenido
loading

Tabla de contenido