Know Your Snow Thrower - Craftsman 536.881950 Manual Del Operador

[o_o)_l
KNOW YOUR SNOW THROWER
READ THiS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING
YOUR SNOW THROWER. Compare the illustrations with your SNOW THROWER
to familiarize yourself with the location of various controls and adjustments. Save
this manual for future reference.
Primer Choke Control Gas Cap Augers--- (left handDrive) Lever
Button Drive Lever
(right hand)
Crank
j Assembly
Chute
Deflector
Safety
Key
Recoil Starter Handle
Discharge
Chute
Shear Pin
Scraper Bar Figure 9
Auger Drive Lever - Starts and stops
the auger and impeller (snow gathering
and throwing)
Traction Drive Lever - Propels the
snow thrower forward and in reverse.
Speed Shifter Lever - Selects the
speed of the snow thrower (6 speeds for-
ward and 2 speeds reverse).
Crank Assembly - Changes the direc-
tion of snow throwing through the dis-
charge chute.
Chute Deflector - Changes the distance
the snow is thrown.
Discharge Chute - Changes the height
and direction the snow is thrown.
Height Adjust Skid - Adjusts the ground
clearance of the auger housing.
Safety Key - Must push in to start the
engine.
F-051005L
12
Recoil Starter Handle - Starts the en-
gine manually.
Choke Control - Used to start a cold
engine.
Primer Button - Injects fuel directly into
the carburetor manifold for fast starts in
cold weather.
Electric Start Button - (if so equipped)
Used to start the engine using the 120 V
electric starter.
Shear Pin - Shear pins are designed to
break (to protect the machine) if an ob-
iect becomes lodged in the auger hous-
ing.
Toolbox - Spare shear pins and spacers
are located in toolbox.
Clean-Out Tool - Use the clean-out tool
to remove snow and debirs from the dis-
charge chute and the auger housing.