Troubleshooting Guide - Castex UV-1600 Manual Del Operador

OPERATION

TROUBLESHOOTING GUIDE

PROBLEM
The vacuum will not pick up dirt.
The vacuum will not run.
8
CAUSE
The vacuum bag is full.
The hose is clogged.
The hose is loose from the brush
base.
One or both hose cuffs are loose.
The brush clogged and caused the
brush circuit breaker to trip.
The secondary filter is clogged.
The brush drive belts are worn or
broken.
The power cord is not plugged in or
there is a short in the power cord.
The power outlet is not providing
electricity due to a circuit breaker that
has tripped in the building.
The vacuum motor has shut off on
thermal overload due to clogged hose,
vacuum bag, secondary filter or
exhaust filter.
The brush clogged and caused the
brush circuit breaker to trip.
Faulty master switch.
Loose or broken wiring inside the
vacuum.
Home Find... Go To..
SOLUTION
Install a new paper vacuum bag or
empty the cloth bag.
Remove clogs from hose.
Push the hose cuff firmly into the
brush base after cleaning with
attachments.
Hold hose in one hand and turn cuff
with the other hand until it is tightly
threaded onto the hose.
Unplug the machine, then remove
the clog. Push the brush reset button
at the rear of the vacuum.
Remove the filter and clean or replace
it.
Replace the drive belts.
Check that the power cord is plugged
in and also inspect it for damage.
Try plugging the machine into another
power outlet.
Check all these locations for clogs.
Unplug the machine, then remove
the clog. Push the brush reset button,
at the rear of the vacuum.
Contact Service Center.
Contact Service Center.
UV-1600 (03- -99)