Sears Kenmore 106.8955 Manual De Uso Y Cuidado página 10

Gravity Drain System
Connect the ice maker drain to your drain in accordance with
all state and local codes and ordinances. If the ice maker is
provided with a gravity drain system, follow these guidelines
when installing drain lines. This will help keep water from
flowing back into the ice maker storage bin and potentially
flowing onto the floor, causing water damage.
• Drain lines must have a minimum of 5/8" (15.88 mm) inside
diameter.
• Drain lines must have a 1" drop per 48" (2.54 cm drop per
122 cm) of run or 1/4" drop per 12" (6.35 mm per 30.48 cm)
of run and must not have low points where water can settle.
• The floor drains must be large enough to accommodate
drainage from all drains.
• The ideal installation has a standpipe with a 11/2" (3.81 cm)
to 2" (5.08 cm) PVC drain reducer installed directly below
the outlet of the drain tube as shown. You must maintain a
1" (2.54 cm) air gap between the drain hose and the
standpipe.
IMPORTANT: A drain pump is necessary when a floor drain is
not available. A Drain Pump kit, Part Number 1901A, is
available for purchase.
Side View
I
I
I
17/8 II
(4.8 cm)
I i23
(58.4 cm)
A. Drain hose
B. 1" (2.54 cm) air gap
C. PVC drain reducer
2"-11/2 ''
(5 cm - 3.8 cm)
D. Center of drain should be 23" (58.4 cm)
from front of door t with or without the 3_,,
(7.91 cm) panel on the door. The drain
should also be centered from left to right
(7_6" [78.56 cm] from either side of the
ice maker).
Drain Pump System (on some models)
IMPORTANT..
• Connect the ice maker drain to your drain in accordance
with the International Plumbing Code and any local codes
and ordinances.
• The drain pump discharge line must terminate at an open
sited drain.
• Maximum rise 10 ft (3.1 m)
• Maximum run 100 ft (30.5 m)
NOTES:
• If the drain hose becomes twisted and water cannot drain,
your ice maker will not work.
• It may be desirable to insulate the drain line thoroughly up
to the drain inlet. An Insulation Sleeve kit, Part Number
W10365792, is available for purchase.
Connecting the Drain
After ensuring that the drain system is adequate, follow these
steps to properly place the ice maker:
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
Excessive Weight Hazard
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
2. Style 1--For gravity drain system, push the ice maker into
position so that the ice maker drain tube is positioned over
the PVC drain reducer. See "Gravity Drain System."
Style 2--For drain pump system connect the drain pump
outlet hose to the drain. See "Drain Pump System."
3. Recheck the ice maker to be sure that it is level. See
"Leveling."
4. If it is required by your local sanitation code, seal the
cabinet to the floor with an approved caulking compound
after all water and electrical connections have been made.
10