Technical Data - IKRA EKSN 1800-35 Instrucciones De Manejo

Electric Chainsaw
Introduction to the Operating Instructions
These Operating Instructions are intended to facilitate your becoming acquainted with the machine and using it in
accordance with the regulations. The Operating Instructions contain important information on how to use the machine
safely, correctly and economically. Observing this information will help increase the reliability and working life of the
machine. The Operating Instructions must always be at hand when the machine is being used.
They must be read and observed by every person dealing with the machine, whether operating, servicing or trans-
porting it.
In addition to the Operating Instructions and the applicable rules of the prevention of accidents valid in the country
of use and on site, the generally recognised rules on working safely and correctly must be observed as well as the
accident prevention rules of the relevant professional associations.
Illustration and explanation of pictograms
1 2
1+2 Wear eye and ear protection!
3 Warning!
4 Read operation instructions before use
5 Do not subject this electric power tool to rain
6 Remove plug immediately if the power flex is damaged or cut.
7 Attention, kick-back!
8 Hold tool with both hands!
9 Attention: Environmental Protection! This device may not be disposed of with general/ household waste. Dispose
of only at a designated collection point.

Technical Data

The devices are manufactured in accordance with the provisions of EN 60745-2-13 and fully comply with the provi-
sions of the German Equipment and Product Safety Act.
Model
Rated Voltage
Nominal Frequency
Fuse (time lag)
Rated Output
Guide Bar
Cutting length
Chain
Speed
Weight
Oil
All models with automatic chain lubrication and mechanical chain brake and rundown brake.
Class of Protection:
Interference Suppression:
Noise emission information in accordance with the German Product Safety Act (ProdSG) and the EC Machine Directive:
Noise emission values EN 60745-2-13: Sound Pressure Level L
Vibration values in accordance with EN 60745-2-13: 3,77 m/s
Attention: This chain saw is only intended for cutting wood !!!
3 4
EKSN 1800-35
V~ 230-240
Hz 50
A 16
W 1800
mm 360
mm 340
91 PJ 052X
m/sec approx. 13
approx. 5,3
kg
ml 140
II/DIN EN 60745/VDE 0740
according to EN 55014
5 6
83,43 dB (A)
pA
GB-2
7 8
K 3,0 dB(A)
2
K 1,5 m/s 2
9