Troubleshooting; Optional Accessories - Dolmar AK-3622 Manual De Instrucciones

than 2 m away from the equipment. Failure to do this
may cause removal of warning/caution labels, above-
mentioned-electrical part damage and flood into the
gearbox casing resulting in damage to mechanical
parts, such as gears, bearings and the like.
Follow warnings, cautions and instructions stated in
labels and instruction manual of the power washer for
proper use. Failure to do this may cause a personal
injury and failure, damage or breakage to the
equipment.
TROUBLE SHOOTING
Problem
Neither the battery lamp nor the
warning lamp lights up even after
pressing the main switch.
With either one battery of the two
battery lamps lighted up, the
warning lamp light up after pressing
the main switch.
The cultivator blade does not rotate
even pulling the switch lever.
The warning lamp and the battery
lamp light up during operation.
The tool stops
suddenly. And the
warning lamp lights up
or is blinking.
The blade does not stop.
012848

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recommended
for use with your Dolmar tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Dolmar service center.
• Dolmar genuine battery and charger
• Holder
Battery cartridge is not installed.
Lock key is not inserted.
Malfunction of the main switch.
Battery is low.
Battery is not inserted properly.
Malfunction of battery lamp or warning
lamp.
The main switch is not pressed.
The lock-off button was not pressed.
The lock key is not inserted.
Malfunction of the switches.
Battery is low.
light up The blade digs too deep, and the motor
is over loaded.
blinking An obstacle gets stuck on the blade.
Switch lever is broken.
• If the battery ports or the area around them should be
splashed with water or flooded during cleaning, wipe it
off with a rag immediately.
3. Check all nuts, bolts, knobs, screws, fasteners etc. for
tightness.
4. Inspect moving parts for damage, breakage, and
wear. Have repairs made on any damaged or missing
parts.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by DOLMAR Authorized Service Centers,
always using DOLMAR replacement parts.
Possible cause
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
Noise
The typical A-weighted noise level determined according
to 2000/14/EC:
Sound pressure level (L
Uncertainty (K): 2.5 dB (A)
The noise level under working may exceed 80 dB (A)
Remedy
Install the battery carridge.
Insert the lock key.
Ask your local Dolmar Service Center.
Lock key is pulled out. Charge the
battery.
Remove the battery, and insert it again
carefully.
Ask your local Dolmar Service Center.
Press the main switch.
Keep pressing the lock-off button when
you pull switch lever.
Insert the lock key.
Ask your local Dolmar Service Center.
Charge the battery.
Change the depth of cultivation
shallower.
Turn off the tool by pressing the main
switch. Then remove the obstacle
carefully.
Turn off the main switch.
Remove the battery cartridge.
Ask your local Dolmar Service Center
immediately.
): 70 dB (A) or less
pA
Wear ear protection.
ENG905-1
13