Instructions For Assembly; Technical Data - Neriox STANDLUPE LED Instrucciones De Uso

3
150981
STAND MAGNIFYING GLASS LED
Operating Instructions

Instructions for assembly

• Remove the stand magnifying glass from its packaging and place it on a
flat surface.
• Check all parts.
• Adjust the neck and the inclination of the lamp in the desired position.
• Connect the power supply to the lamp cable, plug the power supply into
the power point (100-240V) and turn on the lamp.

Technical data

Stand magnifying glass with integrated LED lighting.
The image is sharply contoured and distortion free.
Features
SMD LED lighting ring with 24 LED (white) 4.5W
LED life span 50,000 hrs.
Glass lens, 3 dioptres
Protective cap for glass lens
Flexible gooseneck
Stable lamp base Ø 160 mm
Main switch on lamp base
Operating temperature – 10°... + 40°
Magnification Lens size
1.75 x Ø 85
Delivery content:
Complete with cable and power supply
Brütsch/Rüegger Werkzeuge AG, Heinrich Stutz-Strasse 20, Postfach, CH-8902 Urdorf, Tel. +41 44 736 63 63, Fax +41 44 736 63 00, www.neriox.tools, sales@brw.ch
Reflector size
mm mm
Ø 135
Warnings for safe operation
• Never look directly into the LED light (risk of eye injury)
• Never operate the lamp without installed LED protection cover
• Never disassemble or modify the device
• Protect the device against liquids and moisture
• Keep device away from flammable materials
• Keep device away from curtains, fabrics and similar materials
• Keep device away from direct sunlight (cover magnifying glass when not in use)
• Protect device against mechanical damage
• Disconnect the device immediately from the circuit in case of
overheating - detach the mains plug
• Do not touch the lamp head or housing in case of overheating
• Do not tilt the lamp backwards
• Dispose of the device properly
Luminous flux Colour
temperature
lm K
270 4500...5000
Repairs
If the device is defective, please contact our
service centre → Servicecenter@brw.ch
Gooseneck Colour
length
mm
290 black
on /off
Weight
kg
1.05