Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
_,,-,I,,',]
=I _vj
I--I _-I
How To Set The Skid
Height
The snow thrower is equipped with
height adjustable
skids mounted on
the outside of the auger housing. See
Figure 12. To adjust the height of the
skids, see "How To Adjust The Height
Of The Skids" in the Maintenance
section.
Adjustable Skids
Figure 12
How To Set
The Length
Of The Cables
The cables were adjusted at the factory
and no adjustments should be neces-
sary. However, after the handles are put
in the operating position, the cables can
be too tight or too loose. If an adjust-
ment is necessary, see "How To Check
And Adjust The Cables" in the Service
And Adjustment section.
_" CHECKLIST
Before you operate your new snow
thrower, to ensure that you receive the
best performance and satisfaction from
this quality product, please review the
following checklist:
_' All assembly instructions have been
completed.
v'
The discharge chute rotates freely.
v" No remaining loose parts in carton.
While learning how to use your snow
thrower, pay extra attention to the fol-
lowing important items:
_'
Engine oil is at proper level.
v'
Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline.
v'
Become familiar
with all controls-
their location and function. Operate
controls before starting engine.
F-011068L
11
Publicidad
Tabla de contenido
