Spectroline MAXIMA ML-3500 Serie Manual Del Operador página 3

English
Micro Discharge Light (MDL) UV-A Lamps
INTRODUCTION
The MAXIMA ML-3500 series ultra-high intensity UV lamps feature micro discharge light
™
(MDL) technology to make all inspections easier, safer and more reliable. The MAXIMA
series lamps are available in three line-voltage models: ML-3500S, with a spot bulb;
wider range. All "M" model MAXIMA lamps operate in both alternating (AC) or direct current
hours and a battery charger and carrying case. Each comes equipped with a detachable
AC cord for the country of shipment (120V, 230V, 240V, or 100V).
Ultraviolet radiation emitted from this product. Avoid exposure. ALWAYS WEAR
PROTECTIVE CLOTHING. EXPOSURE MAY CAUSE PREMATURE AGING OF THE
SKIN AND CANCER. ALWAYS WEAR PROTECTIVE EYEWEAR; FAILURE TO DO
SO MAY RESULT IN SEVERE BURNS OR LONG TERM INJURY TO EYE. Never
look directly into the lamp. Exposure can cause eye and skin allergy and allergic
reactions. Medications or cosmetics may increase your sensitivity to ultraviolet
radiation. Consult physician before operating this product if you are using
medications or have a history of skin problems or believe yourself especially
sensitive to sunlight.
FOR PROFESSIONAL EXAMINATION USE ONLY
IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions.
2. Care must be taken, as burns can occur from touching hot parts.
3. Do not operate the lamp with a damaged cord or if the lamp has been damaged.
4. Wear UV-absorbing protective eyewear (such as the UVS-30 glasses provided) when
operating this or any UV lamp.
5. The filter lens will become hot during use. Never operate the lamp with the UV filter lens
removed.
6. Never use this equipment in any manner not specified in these instructions because the
protection provided by the equipment may be impaired.
NOTE: Due to the ultra-high UV-A intensity produced by this lamp, subject
(penetrants, metals, plastics) fluorescence may fade after a period of exposure.
Therefore, this lamp should not be left shining on any one area for an extended
period.
ML-3500S AC OPERATION
1. Connect the plug to a power source that complies with the electrical requirements
specified on the lamp's label. For best performance and durability, the power source
should be regulated, surge free and noise free. In those regions where mains may
experience fluctuations greater than ± 10%, an overvoltage protection device is
available.
2. Press ON the BLACK ballast rocker switch.
ELECTRICAL SPECIFICATIONS—ML-3500S MODELS
MAXIMA
ML-3500S
Model
120V/60Hz/
Power Source
1.00A
MAXIMA ML-3500 Series
™
U.S. Patent No. 6,573,665
DANGER
ML-3500S/F ML-3500S/FB
230V/50Hz/ 230V/50Hz/
0.75A
3
ML-3500S/FA
240V/50Hz/
0.75A 0.75A
ML-3500/SJ
100V/50-60Hz/
1.00A