Installation Steps - Cooper Lensed High Bay Instrucciones De Instalacion, Mantenimiento Y Funcionamiento

Installation Instructions – Lensed High Bay

Installation Steps:

WARNING: Always turn Off the supply from main circuit breaker first!
• Remove the LED laminaire from packaging and inspect for any damage. Handle LED luminaire with care.
• TO INSTALL WITH CHAIN MOUNT: Install the chain into the provided wire hanger. Secure the other end of the chain to
a structure using hardware rated for the load. Install the wire hanger into the slots on the top of the LED luminaire end
piece.
• Make sure the wiring hangers are fully engaged into the slots on the top channel.
• Connect the LED high bay wiring to incoming power lines, with black to black, white to white and green to green. Use
only UL listed wire.
The purple and grey wires inside the driver compartment are 0-10V (Iow voltage) dimming wires. Connect to low
N ote:
voltage wiring only.
• Clean all residues and fingerprints from the LED luminaire. Double check all hanging hardware before moving onto the
next installation.
E: Lens Removal
STEP 1: Remove the screws attaching the lens end cover to the luminaire body, and remove the lens end cover.
4
COOPER LIGHTING SOLUTIONS IB507009EN Installation instructions
Lens End Cover