Introduction; Supply List; Variants - Studer Innotec X-Connect Manual Montaje

I
NTRODUCTION
1 9 B
Congratulations! You just purchased the X-Connect, a mounting grame to assemble a multi-
Xtender system.
The X-Connect will offer you a flexible and economical solution for high power systems based on
the inverter form the range XTH. Indeed, it will make much easier the cabling of centralized,
parallel, 3phase or even parallel + 3phase systems.
S upply list
4 0 B
In order to simplify as much as possible the installation of an X-Connect
system, the mounting frame is supplied with the following items :
V ariants
4 1 B
Beyond the system cabling (centralized, parallel, 3phase, parallel + 3phase), the X-Connect is a
system open to different cabling variants.
Cabling flexibility*
The X-Connect has been designed to offer a large range of cabling
possibilities in order to best adapt to each environment.
Four ∅ 50 mm holes on each side of the frame enable input and output
cabling (AC and/or DC) by either plugs/sockets or glands or installation
channels. These inputs/outputs can likewise be carried out downwards via
channels. If this later solution is chosen, the installer will take care not to seal
the apertures down of the fixing frame. These apertures allow on one side the
cables input and on the other side the Xtender ventilation air entrance.
Studer Innotec recommends deeply the installation of plugs/sockets at the
input/output of the system. This allows a simple and secure by-pass of the
system during maintenance operations.
System multi X-Connect
It is possible to combine up to 9 Xtender (3 X-Connect systems) allowing to reach a total power of
72kW.
*The output cabling as well as the glands (or 400VAc plug and socket) are not supplied with the X-Connect. For the cabling,
do go to appendix 1 of the Xtender manual.
1. Pre-installed DC circuit breakers
2. Pre-installed DC fuses
3. Pre-installed DIN rails
4. Interconnection pipes and glands for auxiliary contacts wiring
5. Interconnection pipe and gland for AC wiring
6. Interconnection pipes and glands + 90mm
with appropriates ring tongues for DC wiring from Xtender to
breakers and fuses
Screws set for frame assembly.
X-Connect
EN
wire terminated
2
9