Electrical Safety; General Safety - Simer 2805E-01 Manual Del Usuario

Safety
READ AND FOLLOW
SAFETY INSTRUCTIONS!
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if
ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if
ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The label NOTICE indicates special instructions which
are important but not related to hazards.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
WARNING
Hazardous voltage.
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply. Disconnect power
before working on pump,
motor or tank.
For parts or assistance, call Simer Customer Service at
Wire motor for correct
voltage. See "Electrical"
section of this manual and
motor nameplate.
Ground motor before
connecting to power
supply.
Meet National Electri-
cal Code, Canadian
Electrical Code, and local
codes for all wiring.
Follow wiring instruc-
tions in this manual
when connecting motor to
power lines.

ELECTRICAL SAFETY

Hazardous voltage. Can shock, burn or
kill. Capacitor voltage may be hazardous. To discharge
the motor capacitor, hold the insulated handle screw-
driver BY THE HANDLE and short the capacitor termi-
nals together. Do not touch the metal screwdriver blade
or capacitor terminals. If in doubt, consult a qualified
electrician.

GENERAL SAFETY

Burn hazard. Do not touch an operating
motor. Modern motors are designed to operate at high
temperatures. To avoid burns when servicing pump,
allow it to cool for 20 minutes after shut-down before
handling.
Do not allow the pump or any system component to
freeze. To do so will void the warranty.
Pump water only with this pump.
Periodically inspect the pump and system components.
Wear safety glasses at all times when working on pumps.
Keep the work area clean, uncluttered and properly light-
ed; store properly all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
Hazardouse pressure. Risk of explosion.
Pump body may explode if used as a booster pump
unless a relief valve capable of passing the full pump
flow at 75 psi is installed.
1-800-468-7867 / 1-800-546-7867
2
WARNING
Hazardous pressure!
Install pressure relief
valve in discharge pipe.
Release all pressure on
system before working on
any component.