Credit Card Shredding
The Stack and Shred 500X can shred credit cards. Switch the
shredder to auto mode, then;
Lift up the paper loading door (see fig 5).
1
Insert the credit card into the roller as shown in fig 8. Only
2
shred one (1) credit card at a time.
Close the paper loading door (see fig 2).
3
Swingline encourages customers to recycle shredded
paper. Please note that shredded paper cannot be
recycled if mixed with credit card shards. If recycling,
please separate shredded paper and credit cards.
Bin Full
The shredder will not function when the bin is full and the bin
full symbol (
) is illuminated. You should empty the bin.
• Open the door and slide out the waste sack support frame.
• Carefully remove the waste sack from the frame.
Self-cleaning Cutters
After emptying and replacing a full bin, the shredder will run
in reverse for 4 seconds, stop for 2 seconds and then forward
for 4 seconds to clear away any remaining paper from the
cutter mechanism. This unique 'self-cleaning' mechanism is
additional jam prevention technology from Swingline.
Comb Bind Removal Hooks
Note – Use only on standard CombBind strips.
Open bin door.
1
Place document onto the comb bind hooks (see fig 9).
2
Pull down on the document to remove comb strip.
3
Maintenance
The rollers on the auto-feed mechanism may become dirty over
time, please wipe clean with a dry cloth to maintain maximum
product performance (see fig 10).
The auto-start infra-red sensor, located in the paper feed
entry-slot, can occasionally become covered in paper-dust
causing the shredder to run despite no paper being fed into
the machine. Switch the shredder off at the rear of the
machine and carefully clean the sensor using a cotton-swab
(see fig 12).
Service
Your shredder comes with a 2-year on-site service included.
Shredder Accessories
We recommend that a paper waste bag for recycling shredded
paper is used on all models.
Accessory
Recycling Waste Bag
Oil Refill Bottle
Part Number
1765030EU
1760049
8