Ordering Replacement Parts - EINHELL ERGOTOOL E-HKS 1500-Laser Manual De Instrucciones

Anleitung E-HKS 1500 Laser
Do not use flanges or flange nuts with a hole
which is larger or smaller than that of the saw
blade used.
Do not try to stop the saw blade with your hand or
by applying pressure to the side of the blade.
The hinged guard must not jam and must return to
its original position once work is completed.
Before plugging in the circular saw, check that the
hinged guard is functioning properly.
Before each use, always check that the safety
devices - the hinged guard, splitter, flanges and
adjustment devices - are functioning properly and
have been adjusted and secured correctly.
You can connect a suitable dust extractor to the
guard hood. Check that the dust extractor is fitted
securely and properly.
The hinged guard hood is not to be wedged in the
retracted guard hood when sawing.
6. Maintenance
Keep the cooling vents on the motor housing clean
and unobstructed at all times. Blow out any dust
and dirt at regular intervals.
Have a specialist workshop check the carbon
brushes in the event of excessive sparking.
Worn carbon brushes are to be replaced only by a
specialist workshop or by our Customer Service
Centre.
Keep the machine clean at all times.
Never use any caustic agents to clean the plastic
parts.
If ever you discover any damage, consult the
exploded drawing and parts list to determine
exactly which replacement parts you need to order
from our Customer Service Centre.

7. Ordering replacement parts

Please provide the following information on all orders
for replacement parts:
Model/type of device
Article number of the device
ID number of device
Replacement part number of the required spare
part
Replacement part Replacement part no.:
Switch 44.720.50.01.001
Replacement carbon brushes 44.720.50.01.002
05.08.2004 12:59 Uhr Seite 9
GB
9