Panasonic Viera TC-L42D30X Manual Del Operador página 46

Settings
PC adjustments
HDMI settings
• Some menus are grayed out depending on the input signal or condition.
(e.g. "3:2 pulldown" will be grayed out if the input signal is high definition or you are viewing photos, etc.)
Advanced
picture
46
Items Item Description
Reset to defaults Resets PC adjustments.
Sync H & V
On green
Dot clock Alleviates the problem if a picture appears to be vertically-striped, flickers partially or is blurred.
H-position Adjusts the horizontal position.
V-position Adjusts the vertical position.
Clock phase
Alleviates the problem if the whole picture appears to flicker or is blurred.
First adjust the Dot Clock to get the best possible picture, then adjust the clock Phase
so that a clear picture appears.
●
It may not be possible to display a clear picture due to poor input signals.
Input Switches to wide display.
●
VGA (640×480 pixels), WVGA (852×480 pixels), XGA (1,024×768 pixels),
resolution
WXGA (1,280×768 pixels)
●
Options change depending on signals
H-frequency Displays the H (Horizontal)/V (Vertical) frequencies.
Display range
V-frequency
Horizontal: 15 - 110 kHz
Vertical:
HDMI/DVI RGB Auto/
range (HDMI 1-4) Standard
(16-235)/
Nonstandard
Contents type Off/Auto/Photo/
(HDMI 1-4) Graphics
3D Y/C filter Off/On
Color matrix SD/HD
Block NR Off/On
Mosquito NR Off/On
Motion Picture Off/Weak/Strong
Pro 4
Black level Dark/Light
3:2 pulldown Off/On/Auto
The H and V sync signals are input from the HD/VD connector. (p. 54)
Uses a synchronized signal on the Video G signal, which is
input from the G connector. (p. 54)
48 - 120 Hz
Prevents the blown out highlights and blocked up shadows when
a wide-range signal is received. Selects between standard RGB
range (16-235 bits) or non-compliance (0-255 bits).
Auto: Switches the RGB range (Standard (16-235)/Nonstandard)
depending on the HDMI signal information.
Sets content type to each HDMI input.
Auto: Switches content type automatically depending on the
HDMI signal information.
Photo: Best setting for JPEG viewing.
Graphics: Best setting for On-Screen display of connected
equipment.
Minimizes noise and cross-color in the picture.
Selects image resolution of component-connected devices.
SD: Standard Definition
Only used with 480p video signal.
Reduces noise of specific digital signals of DVD, Cable box, etc.
Reduces HDTV flicker noise in the contoured sections of an
image.
Improved moving picture quality by reducing motion blur.
Selects Dark or Light. Valid only for external input signals.
Adjusts the picture recorded in 24 fps for optimum quality.
HD: High Definition