Test Mode (T) - Trilux LMS HFS RMC Instrucciones De Manejo

Test mode
The test mode is for testing the detection ran-
ge of the sensor. For this the luminaire swit-
ches on independent of movement and then off
again if no movement has been detected for a
period of 2 seconds.
After activating the mode (control LED in
luminaire flashes in 2 second cycle) this is
active only until no movement is detected for
30 seconds. Pressing and holding the T button
again (5 seconds) prematurely terminates
test mode (control LED acknowledges with 2
second flashing sequence).
56 57