Installation; Installing The Leveling Legs - Transform QL652 Manual Del Usuario

Installation

INSTALLING THE LEVELING LEGS

Carefully check the utility sink for damage and/or missing parts prior
to installation . If there is any damage or if you are missing parts,
do not proceed with the installation . Report damage and/or missing
parts immediately to the manufacturer . Do not dispose of packaging
before you are satisfied with your new utility sink.
- Remove the utility sink (D) and place it on a soft, protective
surface (Fig . 1) .
- Gently place the cabinet (A) onto its back on a soft, protective
surface .
A
- Screw the four leveling legs (G) into the pre-installed nuts on
the bottom of the cabinet (Fig . 2) .
- Gently right the cabinet .
- Using a carpenter's level, turn the base of each leg until the
cabinet is level .
NOTE:
The caster (H) is pre-installed.
QL652
WARNING:
Always wear safety goggles and gloves during
installation .
CAUTION:
Do not place side load on the leveling legs when
righting the cabinet as they may break .
D
Fig . 1
G
Fig . 2
6
H