Kenwood KDC-C521FM Manual De Instrucciones página 24

Troubleshooting Guide
The messages shown below display your systems condition.
EJECT: No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
Load the disc magazine properly.
➪
NO DISC: No disc has been loaded in the disc magazine.
Load a disc into the disc magazine.
➪
TOC Error: No disc has been loaded in the disc magazine.
Load a disc into the disc magazine.
➪
The CD is quite dirty. The CD is upside-down. The CD is scratched a lot.
Clean the CD and load it correctly.
➪
E-77: The unit is malfunctioning for some reason.
Press the reset button on the display unit. If the "E-77" code does not disappear, consult your nearest service center.
➪
Mecha Error: Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.
Check the disc magazine, and then press the reset button on the display unit. If the "Mecha Error" code does not disappear,
➪
consult your nearest service center.
Hold Error: The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F),
stopping all operation.
Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F),
➪
the disc will start playing again.
ANTENNA ERR: The antenna is not connected correctly.
Make sure the antenna is connected correctly and then turn OFF/ON the SIRIUS source or Display unit.
➪
TUNER ERROR: Broadcast cannot be received due to an error in this unit.
Turn OFF/ON the SIRIUS source or Control unit, or press the reset button on the Display unit.
➪
ESN ERROR: The ESN (Electronic Serial Number) is not registered in Sirius satellite radio tuner unit.
Consult your nearest service center.
➪
LINE ERROR: Neither a disc changer nor the Sirius satellite radio tuner is connected.
Connect a disc changer or the Sirius satellite radio tuner.
➪
The number of disc changers and Sirius satellite radio tuners exceeds the limit of connection to this system.
Up to two units can be connected. Rearrange your connection not to exceed the limit of the connection.
➪
E02
E04
E77
E0d
E77
— 24 —
E77
E77
E77
E01
E99
E77