Before The First Use; Power Sources; Battery Power - AudioSonic CD-1586 Manual De Instrucciones

Before the firSt uSe

• Take the appliance and accessories out the box. Remove the stickers, protective
foil or plastic from the device.
• Place the device on a flat stable surface and ensure a minimum of 10 cm. free
space around the device. This device is not suitable for installation in a cabinet or
for outside use.

PoWer SourceS

ac power
you can power your portable system by plugging the external AC/DC adaptor into
the DC inlet at the back of the unit and into a wall AC power outlet. Check that the
rated voltage of your appliance matches your local voltage. Make sure that the AC
adaptor is fully inserted into the appliance.

Battery power

Insert 8 x "C" size batteries into the battery compartment. Be sure that the batteries
are inserted correctly to avoid damage to the appliance. Always remove the batteries
when appliance will not be used for a long period of time, as this will cause leakage
to the batteries and subsequently damage to your appliance.
notes:
Use batteries of the same type. Never use different types of batteries together.
When using the appliance with batteries, disconnect the AC/DC adaptor.
uSe
radio
• Press the power button to turn on the device.
• Press the source button repeadly to switch to the tuner mode.
• Use the tuning control button to tune to your radio station, note: turn the knob
until you hear a click. When you hold the knob for a several seconds the device
will search automatically.
• Note: fully extend the telescopic antenna and rotate it for the best reception.
6
Instruction Manual
Storing your favorite radio station
Tune to your favorite station, press the [prog/mem/mode] button, the memory cell
number will flash. Use with the skip buttons the designated memory cell number
and confirm with the [prog/mem/mode] button. From now on you can choose your
favorite station by using the skip buttons during radio playback.
Play a disc
• Press the power button to turn on the device.
• Press the source button repeadly to switch to the CD mode.
• Open the CD door, load a disc on the disc tray with the label side facing up and
clolse the CD door.
• Press the [play/pause] button to pause or resume the playback, press the [stop]
button to stop the playback.
Play an uSB/SD/MMc
• Press the power button to turn on the device.
• Press the source button repeadly to switch to the USB or card mode.
• Insert an USB tot the USB port or insert a SD/MMC card to the card slot.
• Press the [play/pause] button to pause or resume the playback, press the [stop]
button to stop the playback.
Skip tracks
• Press the skip buttons to go to the next or previous track.
• Press and hold the skip buttons to search at a quick rate for a specific point to play.
• Press the [+10/album] button to skip 10 tracks ahead.
• Press and hold the [+10/album] button to skip to the next album.
Play modes
During playback, pres the [prog/mem/mode] button to switch among several play
modes.
For CD
• Press once: repeat a single trak
• Press twice: repeat all tracks
• Press three times: random play mode
• Press four times: introduction play mode
• Press five times: exit