Orbegozo SP 6500 Manual De Instrucciones página 17

SP 6500
Note: if you don't set the temperature or weekly program, the heater will turn off automatically after
continuous use of 12 hours and enter into standby.
5. Temperature setting. While the appliance is working, press "+" or "-" buttons, display will show "23",
default temperature. Display also will show "ºC". Press "+" or "-" to set the desired temperature
(temperature range 10-49ºC). For example: the current temperature of the room is 15ºC, when you set
the heater temperature to 25ºC, display will light on as below picture. If you want to cancel selected
temperature, press "F" or
will light off on display.
Remote control operation
Note: during operation, ensure remote control aims to receptor on appliance to working correctly.
1. Press to turn on the heater, fan function will active and display will light as pic. A.
2. Press once, heater will work in min. Power heating and display will show
Power heating and display will show
3. Timer function
4. Set current time/day (it can be set under standby mode & working status): press
display shows the hour, press "
show minutes, press "
show the day "
the configuration, display will show previous setting. For example: setting to Wednesday, 9:30 AM, 25ºC,
max. power of heating, display will be:
in remote control to select max or min power instead of temperature. "ºC"
/
A
works the same as timer button on control panel.
/ " to set current hour (total 24 hours) ; press
/ " to set current minutes (00-59 minutes); press
", press " / " to set current day (Monday-Sunday: d1-d7). Then press
(pic. C).
B
(pic. B). Press again, max.
C
button once,
again, display will
for third time, display will
to confirm
17