Adjusting The Axle Shafts And Brakes Unlocking Side Levers; Adjusting The Parking Brake - NIBBI NTR 450 Manual De Instrucciones

7. Adjusting the axle shafts and
brakes unlocking side levers
• If the machine does not turn in a
proper way when the unlocking le-
ver (A) is pressed, adjust it by using
adjuster (B).
• If the machine does not turn in a
proper way when brake lever (C) is
pulled, adjust it by using adjuster
(D) whilst keeping clutch lever in
engaged position (see figure).
IMPortAnt
To safeguard the correct operation
of the release pegs, the adjusting
screw (B) must be adjusted so that
the lever (A) has an idle run of about
2-3 mm.

8. Adjusting the parking brake

cAutIon
• Adjust the brake in order to
keep it efficient and so that is
does not create resistance when
not necessary.
• Check brake efficiency with clutch
lever in release position (parking
brake position).
•If brakes are ineffective, adjust
tension on the brake load spring
(A) and make hook (B) run along
the slot after loosening screw (C)
and afterwards screwing down. To
facilitate this operation, keep clutch
lever engaged.
29