Pu-E Series Pickup Installation; Electrical Installation & Diagrams; P1 Terminal Block Wiring Diagram - DART Controls DM8000 Serie Manual De Instrucciones

PU-E Series Pickup Installation

The PU-E series pickup is an economical way to monitor motor speed. Its patented design provides for
ease of installation in otherwise difficult to reach areas. The PU-E operates from a +5V power supply,
producing a 5 volt square wave whose frequency is proportional to speed. This signal is fed into the
DM8000 control as a speed or position reference for the microprocessor.
washer
10-32
screw
dust magnet
cover disc
black wire
common
DO NOT OVER TIGHTEN MOUNTING SCREW !!
No other mounting screws are necessary, as the
cord will keep the unit from rotating.
Caution: The PU-E cord should not be grouped with other wires or cords. For applications with PU-E
wire over 6 feet long, or noisy environments, a shielded cable is recommended. Connect the shield to the
common terminal on the DM8000, leaving the shield on the PU-E end floating.
Electrical Installation & Diagrams

P1 Terminal Block Wiring Diagram

DM8000
HOOK-UP
* Used for various functions, including quadrature counter mode.
PU-E
bearing
tapped
flat
motor
shaft
3/16"
spacer
red wire
+5 volts
white wire
signal
CAUTION:
NC2
P1-1
C2
P1-2
NO2
P1-3
NC1
P1-4
C1
P1-5
NO1
P1-6
N
P1-7
L
P1-8
COM
P1-9
+5V
P1-10
S1
P1-11
S2
P1-12
PU-2E
PU-4E
PU-10E
PU-20E
PU-20EQUAD
1.60
}
Alarm Output 2 - Normally Closed
Alarm Output 2 - Common
Alarm Output 2 - Normally Open
}
Alarm Output 1 - Normally Closed
Alarm Output 1 - Common
Alarm Output 1 - Normally Open
AC NEUTRAL
AC LINE INPUT
2 Amp
AC LINE
AC LINE INPUT
COMMO black
red
+5VD
SIGNAL 1
white
SIGNAL 2
*
5
Model
Pulses per
Number
Revolution
1
2
5
10
10
Dimensions
.875
2.40
72.00
Form C Relay Output (Programmable)
-R Optional Relay Output
Form C
Relay Output
(Programmable)
}
85-265VAC
PICK-UP
MOUNTED
(Mounts on rotating
end shaft with 10-32
tapped hole, 1/2" deep)