Subwoofer Output - Trevi IPD 8450T Manual De Uso

ENGLISH
COMPONENT VIDEO OUTPUT (Y/Pb/Pr)
By using the Component Video output (Y/Pb/Pr) you can play the videos saved on your iPod/iPhone.
1. Connect a TV/Monitor to the Component Video output (Y/Pb/Pr) described in INSTALLATION AND CONNECTIONS on page 13.
2. Turn on the speaker unit.
3. Plug-in your iPod/iPhone.
4. Press the SOURCE key (12) until IPOD is displayed on the LCD display.
5. Launch a video on your iPod/iPhone.
6. Press the VIDEO key (4) on the remote control to switch to Component Video output (Y/Pb/Pr).
NOTES
Check that the TV/monitor connected to the Component Video output (Y/Pb/Pr) is set on the respective input. Refer to your TV/monitor's user manual.

SUBWOOFER OUTPUT

By using the SUBWOOFER output you can integrate the audio from the speaker with a powered Subwoofer or a Subwoofer connected to
an amplifier.
1. Connect the powered Subwoofer or the amplifier connected to the Subwoofer to the SUBWOOFER output as described in INSTALLATION
AND CONNECTIONS on page 13.
2. Turn on the speaker unit.
3. Turn on the powered Subwoofer or the amplifier.
4. The sound from any source will be integrated with the connected Subwoofer.
TROUBLESHOOTING
If the IPD 8450T does not work properly, check this short list before taking it to an authorised TREVI service centre.
In any case, do not try to repair the device, this will void the warranty. Only TREVI service centres are authorised to perform service ope-
rations on this device.
Radio sound is distorted
Look for the right frequency using manual tuning.

Change the speaker unit's location to allow a better signal reception.

Restore speaker unit's factory settings.

No sound coming from the radio
Check that the source is set on TUNER.

Volume is too low. Turn up the volume

MUTE is enabled. Disable MUTE.

Restore speaker unit's factory settings.

iPod/iPhone does not communicate / has no sound
Check that the source is set on IPOD.

Unplug the iPod/iPhone from the connector and check the connector for dirt or obstructions.

Check that the iPod/iPhone works correctly before placing it into its housing.

Volume is too low. Turn up the volume

MUTE is enabled. Disable MUTE.

Restore speaker unit's factory settings.

The remote control does not work
Replace batteries

18
IPD 8450T