Description Of Parameters - Chauvin Arnoux Statop 4849 Manual De Instrucciones

3.4

Description of parameters

PARA-
Description
METER
SP Setpoint of control
P (%) Manual mode (%)
ASP1 Alarm setpoint
If ALm1 = 0, 1, 4 or 5 :
alarm setpoint value
If ALm1 = 2, 3, 6, 7, 8, 9, 10 or
11 : bandwidth
If ALm1 = 12 or 13 : timer
rr Ramp rate for the process value
oFSt Offset value for manual reset
SHiF Offset shift for process value
Pb Proportional band
ti Integral time
td Derivative time
LoCL Local mode
SEL Parameters selection
(allows selection of additional
parameters to be accessible
at Level 0 security, i.e. without
having to press key for 6 s).
Ct Proportional cycle time
In Input mode selection
ALm1 Alarm mode selection
Process alarms are at fixed
temperature points. Deviation
alarms move with the setpoint
value.
Adjustment Range
LLit...HLit
0...100%
LLit...HLit
0...3600 minutes
If 0 ≤ in ≤ 9 : 0...200 °C/min.
If in = 10 : 0...3600 unit/min.
0...100% (« ti » =0)
-111°...111°C
0...200°C
0% (ON-OFF mode)
0...3600 s
0...1000 s
0 : no control parameters can be changed
1 : control parameters can be changed
0 : none
1 : ASP1
2 : rr
3 : oFSt
4 : ASP1, rr
5 : ASP1, oFSt
6 : rr, oFSt
7 : ASP1, rr, oFSt
0...120 s
0 : thermocouple J
1 : thermocouple K
2 : thermocouple T
3 : thermocouple E
4 : thermocouple B
5 : thermocouple R
6 : thermocouple S
7 : thermocouple N
8 : Pt 100 Ω (DIN 43.760)
9 : Pt 100 Ω (JIS C1604-1981)
10 : linear voltage -10...60 mV DC
0 : process high alarm
1 : process low alarm
2 : deviation high alarm
3 : deviation low alarm
4 : inhibit process high alarm
5 : inhibit process low alarm
6 : inhibit deviation high alarm
7 : inhibit deviation low alarm
8 : outband alarm
9 : inband alarm
10 : inhibit outband alarm
11 : inhibit inband alarm
12 : alarm relay On as Dwell Time output
13 : alarm relay Off as Dwell time output
30
Lt settings
200°C
0°C/minute
20.0%
0°C
10°C
120 s
30 s
1
0
Relay output : 20 s
Analogue output : 0 s
Pulsed voltage : 1s
0
1