Improving Fm Stereo Sound; Recalling Preset Stations - Pioneer F-F3-J Manual De Instrucciones

Listening to FM/AM

Improving FM stereo sound

If the TUNED or STEREO indicator fails to light
when tuning into an FM station due to a weak
reception signal, press the MPX button to
switch the tuner into mono reception mode.
This should improve the sound quality and
allow you to enjoy the broadcast.

Recalling preset stations

POWER
STANDBY
OFF ON
1
4 4
7
MEMORY
10
MENU
ST-
BAND
MPX
For instructions on presetting stations, see the
section "Preset stations" (page 16).
1 Connect the antenna and confirm that
reception is possible.
Press the POWER or  button to turn on
2
the power.
3 Press the MENU button to select menu.
4 Either turn the TUNING/PRESET dial or
press the ST + or ST – button to select the
search mode.
5 Either turn the TUNING/PRESET dial or
press the ST + or ST – button to select
"Preset".
Note
1 The STEREO indicator will light blue when the MPX button is pressed.
TUNING/PRESET
BAND MENU
RDS TUNED STEREO
DISPLAY AUTO PRESET
DIMMER
DISP
2 3
A/B/C
5 6
D/E/F
8 9
G/H
A.PRESET/A.TUNE
I/J
TUNE+
ST+
ENTER
TUNE-
6 Press the TUNING/PRESET dial or ENTER
button to set the preset mode.
7 Watching the display, either turn the
TUNING/PRESET dial, or press the ST + or
1
ST – button to select the desired preset
channel.
7-1 Press one of the preset channel range (A
to J) buttons to select the desired memory
block (A to J).
F3
7-2 Press one of the station call (1 to 10)
buttons to select the desired preset channel
(1 to 10).
• Steps 1 to 5 can be skipped when using the
ST +/–, preset channel range (A to J) and
station call (1 to 10) buttons.
The preset mode is set when any of these
buttons is pressed, regardless of the menu
setting at that time.
04
15
En